Lg Refrigerator Wheel Lock

our refrigerator is covered with them!

Got this for free when I bought the tripod, I was excited to see how well it would work. Of course I didn't expect it to use it as dolly on regular basis but I figure it would be handy at some point.It take a little bit of time to set up at first, but once the part that lock tripod leg to the wheel is in position you wont have to mess with it again unless it's a different tripod. The lock is a little bit of a hassle, I usually didn't even bother to lock them and the tripod seem to stay on the wheel just fine. The tripod I am using is heavy, so having wheel is quite nice when I need to move the tripod. There is a lock on the wheel to keep it in place.As far as using it as a dolly, it's obvious that this wasn't going to work well. However on smooth surface like the wooden floor in my house it looks smooth enough for something that take just a few seconds to set up.Overall it's a great product, but I would say $ is a little too pricey for something that isn't necessary.

It is priced right for certain. It has a plastic wheel lock and I was concerned about that so I called the factory and they assured me none have been returned. It rolls smooth, wheels lock easily and does everything else I want it to do. I have a small home studio and it fills my need just right. Not to mention I found out it is made just a very few miles from me.

I bought a set of casters on Amazon that fit my large stand and they fit, but they were too small a wheel and did not lock onto the legs correctly. The stand and boom fell over and broke equipment. These casters are the only casters you should use and will probably last me forever.

Way better than other bases for C-Stands, it's so nice to be able to wheel around lights and other devices and then lock casters and forget about it, throw a few sand bags on for safety and done. I wouldn't change a thing. Even the footprint is perfect to not be tripping over or taking up half the room! I also like using existing c-stand risers to convert them to wheeled stands.

Have a high end refrigerator that is plug in into it, so far so good!

Just purchased a LG OLED TV and wanted a quality wall mount, just doesn't make a lot of sense hang a $2,000 TV on a $15 mount from Harbor Freight! You can actually feel the quality, and the ability to fine-tune the install is very easy to pull off. My only criticism would be to be pay attention to where your wall box sits in relation to where the mounts attach to your TV. The LG mounts are fairly close together in the center of the screen, and because of a stud located dead-center in my wall I had to offset the box. Problem was the TV mounting bracket hit the edge of this box so I couldn't fully lock it into position. I had to actually notch our the wire box so the TV would properly lock into position. Not a big deal but definitely something worth paying attention to. Very happy with the mount, yes it's expensive but definitely worth it!

Even better than promised. Will try hooking it to my refrigerator.

Strong enough to hold up a refrigerator, I think. Fits perfectly, of course.

Connected to my River, kept my portable refrigerator going all weekend