Mac Says Ethernet Cable Unplugged

Says it all.

The Coupler works great. I had a short ethernet line coming out of the wall and needed to entend the connection to my Mac. I connected the coupler to the ethernet cable, connected my other cable to the coupler and voila, signal to my Mac.

I chose ethernet communication between my Mac and new printer. This snag less ethernet cable with such great performance has proven itself to be a wise investment.

Not much to say about an ethernet cable, except that it works.

Says it all

Short Ethernet cable that works.

Ethernet cable wet dream.

A Ethernet cable that works! And it was low cost.

I DOSE WHAT IT SAYS .

I had another printer that would not properly load the paper through the printer. A friend from "church" knew I needed a printer and gave me this printer. This printer is Brand new and has not been used! I had a little trouble getting it to turn on because I did not have the power cord "seated" fully into the printer. I was getting frustrated so I figured: "I will come back to it after I come home from my dentist appointment." Well after I came home that is when I unplugged the USB cable and unplugged the power cord and then plugged the USB cable back in and then plugged the Power cord back in and gave it an Extra hard shove. This time when I pressed the power button it turned on!! BOY did I feel embarrassed! After the Printer turned on all of the drivers installed with no problems!! I printed 7 pages earlier today with no problems and the "darkness" of the print was perfect! I think some of the problems that some people are experiencing with the "darkness" of print issue may arise from Not checking the settings in the print menu before they print. Why do I say that? I read the eManual and made sure I understood how to operate it before I printed anything! You can "Adjust" the "Darkness" or "Lightness" level of the print in the Print Settings.