Mustang Projector Screen Adjustment

I purchased this unit to mount an ultra-short throw projector on our stage electrical rigging for projected scenery in a musical. With this type of projector a fraction of an inch adjustment on the projector means inches on the screen so precision is paramount. The gear driven adjustments made aligning the image on the screen fast, easy, accurate and reliable. The mechanics are firm, not so tight that adjustment becomes jumpy, not loose enough to wiggle even the slightest bit. I mounted the unit on a pipe attached to our light rigging that is brought in and out frequently. After the initial installation, I never had to re-adjust as a result of the rigging going up and down and stopping suddenly at trim points, and my projections were always perfectly aligned to the sccreen I have used other mounts where you loosen a couple screws, move the projector by hand, then hold everything in place while tightening down the screws and there is no comparison. There's no need to try and compensate for the effects of gravity when you let go of the projector. The image you see while adjusting is the image you'll have after you've climbed down the ladder. All this and a similar if not lower price and there's no reason to go with any other system.

We use this projector screen in our church activities.

I installed them next to my projector screen and they sound great.

Excellent design it comes with USB charger, auto DST adjustment & time projector.

Anyone looking to extend there monitor onto a TV screen or projector this is the way to go.

This was very easy to connect to my projector and the gear adjustment is clever and simple to use with just a regular Phillips screwdriver.

Projector works great. Took a little while to find the adjustment for the picture flip for an upside down mount.

I use this for art installations. Although not as solidly built as the Chief mounts, it is still well made. The best feature is the easy fine adjustment using threaded screws. I've worked with Chiefs and other mounts before, and it's quite difficult to change the angle on the mount by small amounts. Even tightening the set screws can change the angle. With this mount, those problems are gone. BUT, do not use this mount to aim the projector directly down or sideways. The weight of the projector in these non-standard positions will be awkwardly placed onto the adjustment screws, making them difficult to use.

I just started using this device and it works as a lectern and as a stand for my 6# projector.  Nice height adjustment and good table tilt adjustment.  The tension adjusting screws work very smooth.  Overall a really nice device for holding my projector or as a traveling lectern.

This mount is a lot more rigid than the peerless mount I had. It is also very easy to adjust and also has a yaw adjustment that the previous mount did not have. It allowed better projector to screen orientation. It solved my problem of vibrations from someone walking on the floor above where I have the projector mounted.