Need To Make Vintage Projector Screen Wider

I want this projector so badly. Need to know when to expect it and how much it'll cost.

Uncoiled it. Plugged it in. Perfection on the screen. Need I say more?

We use this projector screen in our church activities.

IT'S STICKY, IT'S GREEN, IT'S WORKS WHEN YOU NEED TO MAKE SURE PEOPLE HIT THEIR MARKS, OR NOT TRIP OVER YOUR EQUIPMENT. PUT IT ON YOU FACE AND MAKE A MASK, MAKE SOME STICKY UNDERPANTS. IT'S THE GOOD STUFF.

I installed them next to my projector screen and they sound great.

I use this to convert a 20amp plug on 12k Projector to a 110v outlet. Make sure you still have a dedicated 20amp for your equipment or you will trip the circuit.

I needed a new bulb for my vintage (40+ yrs) Kodak Carousel 760H projector as the one in the device expired in less than 2 hrs. of use. It had not been used since about 1983 and I was concerned that perhaps this legacy bulb was no longer available. B&H to the rescue with this replacement that was just what the owner's guide spec'd. I resumed my project I observed a better quality of image on the screen and the heat generated by the new bulb was noticeably cooler! 2.75 hrs. total use so far.

I purchased a vintage Kodak slide projector and the bulb was burnt. I ordered this projector bulb from B&H and it has the projector working great again.

Anyone looking to extend there monitor onto a TV screen or projector this is the way to go.

Using this to decode an NDI source to a projector in Church services with live stream. We previously were sending the Presentation Laptops screen to the OBS computer via NDI, and used a separate proprietary wireless video feed to the main projector. Got this so we can use the same NDI source for both and eliminate the wireless projector feed. It is working well. One thing to be aware of: the projector will display will go blank in a couple of seconds if there is no video and audio activity when using NDI Screen Capture as the source. This can be an issue during power points with static screens. You can set the decoder to keep the last thing displayed on the screen or allow it to go blank. I prefer it to go blank so I know something is wrong right away. You can also resolve by making sure the NDI Screen Capture is using an active audio source (like the microphone). This decoder has been reliable and is reasonably priced. Perhaps other decoders won't have the inactivity issue but they are also more expensive. This has not been a show stopper for us.