Oven Temp Control Switch

Very bright, even more than I expected. We use it to view oven contents for done looking food.  Easy to read oven temp. gauge also.

One problem with using silica gel to control humidity is how long to heat it in the oven to drive off the water; a second is how to store the dry gel until you use it. This unit takes care of both. When the gel turns pink (visible though a widow), plug it into a 120 V outlet for an hour or so until the gel turns blue. This is easy enough, that the storage of dried gel is a non-issue.

I like how it can be regenerated using a microwave oven.

Nest thermostat works great. Nice to be able to control temp. Of house from anywhere.

I found this very easy to install and use it keeps the temp very good will be using the phone to control it when we go to fla this winter.

lots of control (of color temp and intensity) of this little baby that packs a punch

We love the convenience and efficiency of the Ecobee3. Especially how we can control the temp settings from our cellphone.

I purchased this switch to supply connectivity to an AP and 3 - IP security cameras in a detached garage. This 5 port switch is outdoor in its temp handling range. However it does need to be installed in a weatherproof enclosure or inside a building (with or without climate control.) It DOES NOT have stand alone power, but instead supplies POE power tto itself and downstream devices by being powered by POE into port 1. This means you need to power this with a POE switch or POE injector upstream. It can be powered by 802.3af or at POE, but for any practical install (meaning powering devices downstream of the switch) it needs fed with a 60W 802.3bt POE supply. I'm using a TP-Link 60W POE injector and this works without issue. The switch itself is a full feature Unifi switch. Configured and controlled via a Unifi controller (Cloud Key) it can be setup by a user with intermediate knowledge of networking. Ports feature full VLAN support and control. For my use case, I needed to power an access point and 3 wired cameras. The FLEX is tailor made for this. Port 1 is power in an a trunk port. Port 2 is a second trunk feeding and powering a Unifi 6 Pro AP. Ports 3, 4, and 5 are set to a camera VLAN as well as supplying power. It does get warm to the touch. It passes full line rate speeds. For those already in the Unifi ecosystem and in need of switch for hi/low temp environments, this switch is a good option. I'll update if anything changes or if there are any issues.

I've used the 300d mkii for a while and it is nice to have color temp control. Plenty bright for all my shoots so far.

The CineStill Film °Cs Temperature Control System TCS-1000 has made keeping color chemistry at exact temperature super easy. In the past I was setting chemistry in water baths and constantly adding warm or cool water while I worked to make sure temp was correct. Now I set the temp on the controller and let it do the regulating. Works for black and white chemistry also.