Paper Capacitors Construction

japanese capacitors = high quality

Yes you will get some bass roll off in the very very low end, so it will not go down to 5 hz like a set of 800.00 aphex 124a or 750.00 Arx distribution split. The 20 db of gain is a big plus, and of course having level control pots on all outputs, is an excellent feature. IF you are using to drive multiple low end subwoofers, you may wish to change the output capacitors. Existing ones are 10 uf 50 volt polar electrolytic, and you can easily change for 100 uf 50 volt polar electrolytic for a few dollars. Once you open the case these can easily be seen. The capacitors are easily available and are not expensive. If you try this you will need a solder sucker. Do not try soldering without one. Suck up all the old solder and remove the caps and replace all of then in the existing threw holes. They are marked for positive and negative on the pc board. Once you got them all in place just solder them back in. Once you do this for a few more dollars you can rival any expensive distribution amp. Would be nice if it was more than just 3 inch deep on the case. Most components are at least 6 inches.

I have four 84s and had to have a pair (from 1975) serviced for capacitors and a bias adjustment. One of the capsules had a loose need/pin and caused that mic to almost sound like an omni. Probably a backplate problem. I had the capsule replaced with a new one from Neumann and can't believe how perfectly it matched the other old one from the pair. No noticeable difference between the two, even next to each other above a drum kit. Amazing.

Paper is fine for construction drawings, easy to load and use.

Very pleased with the construction of this product. Built heavy enough for most paper or fabric Backdrops.

I used this paper for printing photographs in a digital lab. I have no complaints about the quality, construction, or durability.

This is an excellent paper for our use. We take photos of our projects before construction begins and these are used for reference during the architectural design and construction drawing phase. This paper is perfect for this. It gives you a very nice photo quality, not grainy. We print 4 photos to a page. The cost is very acceptable also.

I have not used it yet but I like the construction.

Solid construction.

Awesome construction!