Philips Cr2032 Battery

I run through a bunch of CR2032 batteries every couple of months. I like these because battery life has been good, and I can buy them at a reasonable price through B&H.

The RAYOVAC CR2032 Lithium Battery (2-Pack) contained two, count-em two CR2032 cells. Absolutely amazing!!. These were purchased as spares, so I have not measured their voltage yet. Presumably, they will produce the rated 3 Volts and will last for 190 to 240 mAh. They are 20 mm in diameter, shiny and light weight and most likely contains some lithium & manganese dioxide so are technically a LiMn02 cells. FYI: They can explode if heated to more than 80 deg. C.

One of the amazing product from philips. Great

Perfect fit! Works wonderful on my vintage turntable (Philips 212)!

I've been using Philips Hue for almost 10 years and I'm happy with this smart light system.

This SanDisk 8GB player replaces my 12- year-old Philips 4GB player. The Philips battery finally died. The blue-trimmed SanDisk is very cute looking, works great and has a scratch resistant screen. The $19.95 price was a fair, though this player's design is from 2014. All works good, of course. Only minor ding is the 8 seconds it takes to turn it on if it has been off for a few days. Used on a regular basis, it still takes 6 seconds to turn on.

Asus ROG PG278QR. (Wall mount screws are cheaply made, the philips heads will strip out with the slightest resistance, use a ratchet or nut driver and save yourself time) The installation looks harder than it is. Took all of 5 minutes with the right nut driver in my drill after the pilot holes were done. One hole, one nut. Line it up, level it, second (bottom) hole, and screw and that was that for the wall mount portion. Dumped the monitor down on a pillow face first, put the top screws in the VESA mount all but about 8 full turns, and hooked it on the 100mm mount holes made to slide in place on the arm's VESA. Spun in the bottom two screws, tightened, and off I went. With more desk space, and better cable management. (Not that you can see that in the picture, I did the cable management after that was taken!) but it's super easy as well. LIghtweight and holds my ROG 27 without even the slightest grunt or fear of it falling. I mean, use a drill and the right bits (Philips #2 and I can't recall the nut driver size now, sorry) the ONLY problem, is the wall mount screws stripped with a philips bit SUPER DUPER easy, as in, immediately, even with a gripping philips bit. So I went with the nut driver. Zoom, off it went. Cheap screws though.

Really love the build and sound quality which is incredible. Had a few issues connecting to my Philips tv but ones I updated the software it worked perfectly. Hates some Netflix videos as there’s no sound but that’s not a big issue. That not withstanding the sounds great

High quality Philips Truss-Head Screw. Perfect for audio rack equipment installation.

I have owned my Philips 27E1N8900 for over 2 months now. Specs are equivalent to much higher priced competitors. Was able to purchase it for $999.99. Colors and contrast are as expected from an OLED monitor. Make sure to use a DP 1.4 cable as this will give you full 10-bit depth. Refresh is 60hz. I am a moderate gamer, so this is fine for me. I have a 144hz 4K IPS monitor, but the colors/contrast of the OLED is so far beyond the IPS I chose to use the Philips 27E1N8900 for the near perfect picture quality.