Power A Mini Switch Controller

I am using this switch to power a BZBGear camera and BZB controller. Does exactly what it's supposed to do. It's worth buying Netgear, not the cheaper no name units.

The switch was quickly adopted by the controller and was up and running in a few minutes.

Switch is well built with no need for power.

Ordered and received the motion controller 3 from B&H Photo for my Mini 4 Pro. The ordering and shipping of the controller were easy and quick as usual with B&H. The controller works great with the mini 4 and goggles. I struggled a little initially getting used to the controller and functions. A couple of YouTube videos took care of that. For me the motion controller adds a new fun angle in flying the mini 4. With the “point and shoot/fly” I can make maneuvers that would be more difficult using the sticks on the rc2. It does what I wanted it to do. Very satisfied.

Makes using controller software simple as plugging into switch

My Ubiquiti controller adopted and updated the switch perfectly.

After borrowing and testing a set on 3 different shoots I purchased this set. Very easy to set up for Manual Exposure right from the Controller. Controller makes it so much easier to adjust flash power without lowering light stands and manually setting each flash power! Set your FLASH unit on i-TTL so it receives the correct settings from the controller. I've also used it once as a full TTL with the Camera setting the exposure and it worked OK. I also purchased a YN685 flash that works with the controller without using a receiver, but haven't done a shoot with it yet.

Manual Switch works without power.

The power switch works too

Much more capable than the Switch Flex Mini, this pricier sibling is worth every penny if you need: 1) not just a PoE powered switch but a switch that can pass on PoE power to other devices, or 2) a small form-factor switch that fully supports VLAN traffic restrictions, or 3) a switch suitable for outdoor use with the included connection guard. The only thing I wish for at this point is the ability to turn off the LEDs for installations where it's visible in an indoor setting. There is an LED on/off setting for the device on the UniFi controller but it's seems to be completely ignored.