Power A Switch Controller Drift Fix

I am using this switch to power a BZBGear camera and BZB controller. Does exactly what it's supposed to do. It's worth buying Netgear, not the cheaper no name units.

The switch was quickly adopted by the controller and was up and running in a few minutes.

Switch is well built with no need for power.

Makes using controller software simple as plugging into switch

My Ubiquiti controller adopted and updated the switch perfectly.

I had some overcrowded power strips with wall warts. This is a simple fix.

After borrowing and testing a set on 3 different shoots I purchased this set. Very easy to set up for Manual Exposure right from the Controller. Controller makes it so much easier to adjust flash power without lowering light stands and manually setting each flash power! Set your FLASH unit on i-TTL so it receives the correct settings from the controller. I've also used it once as a full TTL with the Camera setting the exposure and it worked OK. I also purchased a YN685 flash that works with the controller without using a receiver, but haven't done a shoot with it yet.

Power squids are irreplaceable. If you don't own one, fix that. This one here is average; 5 outlets, a button to turn power on and off. Works fine, and the cable is nice and long to accommodate out of reach outlets.

Manual Switch works without power.

The power switch works too