Power Backup For Wireless Router

I use this to provide backup power for my satellite internet, wireless router and VOIP phone system. Occasionally, it also powers my laptop and external LCD. Works great and has more than ample reserves. Functions out of the box with Apple Macs and seemlessly integrates with Energy Saver in OS X via the included USB cable. No Cons so far.

It's a must have upgrade router in keeping you in the forefront of wireless power that Synology does so well especially for their well know NAS.

Used for computer, modem, router and monitor power surge protection and backup power.

I have two APC UPS that I use to back up my modem, router and NAS during power outages. My original APC UPS was bought in 2018. This last power outage I noticed the minutes of backup declined rapidly on the older UPS compared to a newer UPS. APC states a two to three year life for backup batteries so I guess six years was time to look for a replacement. This APC replacement was very easy to install and fit perfectly. At half the cost of a new UPS it was an easy decision. My available backup minutes should now be like new

I bought this AP and a related router to replace an aging consumer grade wireless router which I had. Setting up this AP was a breeze and I'd recommend this to anyone wishing to implement or extend a wireless network in their home or small office. The thing to keep in mind is that this is intended to be mounted on a wall or preferably a ceiling. The router only requires a network cable and you use the included power injector to power the unit. This AP will require some other device to route the traffic from your web provider. Configuration is easy with the Unify controller software installed on your pc. Wait for the AP to power on, load the software on your pc (on the same wired network), and let it look for and provision the AP. You can configure a single combined SSID for 2.4 and 5ghz or separate and configure a guest network if so desired. Once configured, the AP has been running without issue solidly for a few weeks now. I have my PoE injector in my office and plugged into my UPS along with my modem, router, and switch. If the power goes out, all of the wireless and internet access will stay up. Be sure to test all your ethernet cables prior to installing everything. I had multiple issues with the cables I was going to use initially. One cable would only allow a max 100 connection, the other would allow gigabit, but the rj45 connector was able to pull back just enough while connected to cause an intermittent connection. Swapping to higher quality cables solved these issues. I have a 3800 sq ft house in an L shape. This AP is on the second floor in the center of the house. This works well for coverage everywhere and I've even seen coverage in areas where I had little to none previously. I've got it mounted in the ceiling of a hallway next to a smoke detector. It doesn't look too out of place except for the blue glow (which can be turned off). I'd recommend this to anyone that has basic networking and computer knowledge looking for a solid access point.

We have frequent power outages so I wanted backup power source as well as line protection for my computer and wireless router. I am able to protect all of my devices with the CP1000. The compact size allows the unit to sit on my computer stand with the other equipment, a big plus.

if your wireless unit fails you, this is your backup.

good power backup

Excellent router that covers my whole home and all my wireless products.

Great router for the budget minded. No wireless.