Power Switch Pro Controller

I am using this switch to power a BZBGear camera and BZB controller. Does exactly what it's supposed to do. It's worth buying Netgear, not the cheaper no name units.

The switch was quickly adopted by the controller and was up and running in a few minutes.

Switch is well built with no need for power.

This is my 3rd AD-200 and my first in the Pro series. I like the new recessed back panel and the power switch being by itself on the side. Great light from a small (but dense) package!

I purchased the hub assembly to tie my 2 Delta pros into my manual generator switch box (6 circuits) back up power to my house. The first one was shipped and I tried it out. It immediately tripped and error 553 showed on both Delta Pros. I called the customer support number and the rep helped me troubleshoot over the phone. She then forwarded the case to the engineers and it was determined that the power hub was defective and a new one was shipped immediately. The new unit works well and now my kitchen, living room and master bed room are powered at the flick of switch. No more running extension cords and unplugging appliances when back up power is needed. I tried to balance loads on the circuits, but if you run the microwave for long it pulls down one Delta Pro quicker than the other. As they discharge I may have to switch Delta Pro Hub inputs to help balance the unit loads. I am pleased with the support and service from ECO Flow and this hub also frees up the 120 volt outlets on the front of the Delta Pros. When I tie in the solar panels I will upgrade to the smart panel and extra Delta Pro batteries..

I use these to power USW-Flex switches. I have three now. Very affordable. Beats having to buy a pro switch to get BT power.

Makes using controller software simple as plugging into switch

My Ubiquiti controller adopted and updated the switch perfectly.

After borrowing and testing a set on 3 different shoots I purchased this set. Very easy to set up for Manual Exposure right from the Controller. Controller makes it so much easier to adjust flash power without lowering light stands and manually setting each flash power! Set your FLASH unit on i-TTL so it receives the correct settings from the controller. I've also used it once as a full TTL with the Camera setting the exposure and it worked OK. I also purchased a YN685 flash that works with the controller without using a receiver, but haven't done a shoot with it yet.

Manual Switch works without power.