Pressure Washer Gas Hot Water Tank

Powers hot water tank, injector pit pump, and fridge effortlessy. Not all at the same time. Individually.

I have used Eneloop rechargeable batteries for a few years and they are excellent and durable. I used it on a gas water heater that needs batteries to create the spark that ignites it. I was unsure if it would work, it works perfect.

The Paterson print washer is a real time-saver. Just a gentle flow of water is all that is needed to activate the auto-agitation which operates without fail.

I've had a couple of these over the years and they always perform perfectly. We are on a well for water so conservation is critical and this print washer minimizes consumption while flushing out chemicals perfectly

I'm usually satisfied with Paterson products and this washer is no exception. It's made of durable plastic and the water hoses are thick and don't feel cheap. It washes paper well even with low water pressure. Worth the money.

Someone please tell me any other film washer better than this.

This processor runs hot. Make sure to use a cooler with lots of ventilation or go with water cooled.

It's big enough to work a 1 liter Paterson tank in it and 2 spools of film. It does get hot and sweaty, if you struggle for 15 minutes Like I did the other day when my corners were sticking and not loading on the spool. The forearm sleeves tend to run on the small side, so if you have large forearm circumference, it is tight. But works very very well. I would of course prefer a full blown darkroom, but I'll keep dreaming. One day.....

I bought this light as a back up from some older tank-y lights that get really hot. I wasn't expecting much from this light given the price, but I was shocked at the quality. This is a no brainer purchase for anyone who needs quality flash lighting with not hot modeling light. I used this with the 7' Impact Umbrella and it performed really well for some portraits. I ended up using this as the key light. Check out the sample photo while I was testing lighting. I also captured a photo with the Full Size Spyder Color Checker, so you can see if there is any color shifting. I didn't notice any. These photos are unprocessed out of the EOS R with an RF 24-105 F4 at about 70mm.

This fixture is built very well. Not quite like tank, but fairly close to it. A note of caution: this unit is very hot. A 750 watt bulb will be hot, I assumed. But I didn't realize the cowling/fixture would get as hot as it gets. Duh. But wow, it is bright. I have to be very careful where I set up this fixture. However, this is my first foray away from inexpensive LED lights. A very important lesson learned, but well worth the money.