Prints Not Sticking To Bed

Immediately updated the firmware, leveled the bed, and it prints like a charm.

This was my first filament ever and it has been the best so far. Prints stick to the bed very easily (I'm using 60C temp for bed) and prints come out outstanding at 0.12mm layer height. Very easy to use, recommended for beginners and experts alike! My favorite filament so far!

In the old days, Enders were the playground of tinkerers. You had to practice bed leveling, nozzle changing, and parameter changes to get good prints. It took time. This Ender 3 v3 SE out of the box makes good prints. Direct drive, 32 bit mainboard, and very quiet to use. A great 3D printer that reduces the learning curve for hobbyists.

This filament prints at approximately 225 C on my printer. Running bed a 90 C. Getting good results and color. I will buy again when this spool gets low.

A really good 3d printer! The removable bed is so much easier to remove prints than my old finder! Remember you must first calibrate the extruder and then level the bed. I would do this twice! Also set the auto bed leveling on. After that it prints great!

In my bed room

It works well, but watch out for pieces sticking together!

Works well. no sticking threads

I use is when i read in bed to charge my tablet.

Great storage drawer for under my bed!