Prints Not Sticking To Bed Ender 3

I printed a few test prints with this on my upgraded Ender 3 pro. My extruder is upgraded to a EZR Struder by SeeMeCNC, no issues what so ever printing this stuff so far. Like others have mentioned, the filament is not in a vacuum sealed bag and only has 1 desiccant packet in the box. At least the box was shrink wrapped. I would order this again when the time arrives.

Immediately updated the firmware, leveled the bed, and it prints like a charm.

This was my first filament ever and it has been the best so far. Prints stick to the bed very easily (I'm using 60C temp for bed) and prints come out outstanding at 0.12mm layer height. Very easy to use, recommended for beginners and experts alike! My favorite filament so far!

This 3d printer was a replacement for an ender 3 pro. Everything about it is better than the Ender 3. If I had to complain about 1 thing. It would be the part cooling fan. It is a loud fan but nothing a closed door to my print area can’t solve.

3.5 x 5 are great for the high volume of prints I have made. These pages work well and make storage more economical.

Works great in my Ender 3S1

3 items that do the job.

In the old days, Enders were the playground of tinkerers. You had to practice bed leveling, nozzle changing, and parameter changes to get good prints. It took time. This Ender 3 v3 SE out of the box makes good prints. Direct drive, 32 bit mainboard, and very quiet to use. A great 3D printer that reduces the learning curve for hobbyists.

This filament prints at approximately 225 C on my printer. Running bed a 90 C. Getting good results and color. I will buy again when this spool gets low.

A really good 3d printer! The removable bed is so much easier to remove prints than my old finder! Remember you must first calibrate the extruder and then level the bed. I would do this twice! Also set the auto bed leveling on. After that it prints great!