Ps5 Controller Holder 3D Print

This is completely compatible with the Zeiss Milvus 15mm /f2.8 lens, as tested on a Nikon D810 with the Lee SW150 Mark II filter holder. The adapter screws onto the lens and fits perfectly, leaving ample access to the focusing ring. The ring is very well made.� The only downside of the ring is that the lens cap cannot be affixed to the front of the lens with this adapter ring in place. Lee makes a plastic cap that can go over the entire adapter ring for the smaller filter system, allowing the ring to be left in place in the field when moving the lens to and from your bag. No such product is made for this larger system. To solve this one problem with the system, I carefully measured the filter adapter ring and 3D printed a plastic cap to go over it. This is probably a bit much for most people, but if you or someone you know is handy with a 3D printer and 3D design, it's not a hard thing to do. Hope this helps. The Zeiss Milvus 15mm is an amazing lens, and this filter holder system is completely compatible with no vignetting. I use the holder system with Lee and NiSi filters.

The controller for the Solo drone needs a little extra help with support for the phone or tablet and this holder does the job. The base of this device fits perfectly onto the controller and lets you control your drone with ease.

My son bought me a Phantom 3 Standard drone for Father's Day and I was needing a case to carry it in. I looked at all types of cases and then found the Nanuk on B&H's website. It was perfect. Ordered it and it got to me very fast. It fits perfect. Took me a little while to figure out how to make the controller fit right, but I upgraded the phone holder to a mid controller holder and it fits perfect in the case. Get this case, you will not be disappointed.

Pros: Easy to use; refill filament, print 3D files, wireless is convenient, and non heating bed. A great value for a 3D Printer. Cons; purchasing expensive filament through XYZPRINTING. Not able to purchase 3rd party filament due to NFC chip.

This is my second 3d printer. It is a fabulous printer the build size is limiting. The performance and print quality are spectacular. Very quiet also.

Love it. Easy to use; decent print quality. This is my first 3D printer and I am totally new to 3D printing. Glad I bought this as my first one as entry level.

The 3D40 Flex 3D print is my first 3D printer. It was easy to set up and bed leveling was extremely easy even for a beginner. It can be connected to the computer with WIFI, USB, or Ethernet. The flexible table makes part removal easy. I've used this printer more than I thought I would before I purchased it. I've been able to create things easily using free software. Dremel provides free slicing software, but I did opt to purchase Simply 3D, which has built-in defaults for my printer. My daughter now calls me a Craft Geek.

My first 3D printer and I love it. The instructions are clear and it is easy to assemble out of the box. There are a ton of youtube videos on this printer so this has helped me a lot. What I found most valuable is to make sure you FIRST mechanically flatten the bed and then do the auto-leveling. I do an auto-leveling before each print because every time I remove a previous print I fear it moves the adjustment. Remember we are printing ~0.12-0.2mm layer heights so I think it is important to auto-level each time. It only takes a minute or two. Also do it with the bed and nozzle at the temperature you are going to print at.

I was going to 3D print a cover for my lens but I saw this and decided to try it. I am glad I did. It is great to protect the lens on my Osmo Action.

So this was my 1st 3d printer I had done my research for quite a while if you want a premium printer that can print right out the box with minimal setup and a large bed this one is for you I might just buy a second one too.