Radio Receivers With Bluetooth

Bluetooth works great is made to hook up to receivers with no pre amp

I have used this with a large umbrella, three sb 700s, and three radio receivers with no problems. I think if you over tightened things, you might have some of the issues other reviewers have mentioned. Worked fine for me!

These receivers work well for hearing in the ear or plugging into a car radio port to transmit the sound of a service. They are extremely reliable and do a great job. The range is extremely far for receiving a signal.

I have only had this radio transmitter for a couple of weeks along with the corresponding receivers and found them so simply to setup and use attached to a Nikon. I only shoot in studio, so I can't say how they work at an event with other photographer. So far I haven't had any miss firing.

I'm not at the budget for some of the higher end radio transmitter/receivers that are out there, and will be using my Quantum in manual mode most all the time off camera anyway. What I needed was a solution to remote fire the Quantum with my Pacific Rim made radio system's receiver, which also terminated in a mini plug. I combined this along with a female to female mini bridge and my needs were solved on the first click. If you need grouping, remote ability to change ratios and power, etc. then more expensive solutions are clearly out there, including Quantum's. However, if you just need simple remote firing, this is a perfect item to work with.

I purchased this case to store my radio transmitters and receivers for my strobes. It is perfect. The clear top allows me to keep track of the equipment at a glance and the case is tough enough to survive my daily travels.

This receiver is what all radio trigger receivers should be. It uses the battery power of the flash. Thus, if you have power for your flash, you have power for the receiver. Super reliable. I have never had a misfire with this receiver. Better than all my Pocket Wizards.

This transmitter is part of the other receivers for radio signaled flashes. It works great. Its compact and it is very affordable.

These radio trigger / receivers are a great value. Solid construction, excellent performance. Works well with my Canon system and my Olympus EM5 Mark II. Should be just fine with any camera that has a standard hot shoe. As long as you don't need TTL, you'd be hard pressed to find anything better for the price.

I purchased two different (and much cheaper) Bluetooth receivers prior to the B1. �Both would cut out again and again even when my iPhone 8+ was only a foot or two away from the unit. �The B1 has not failed me once and it works as far away as the upstairs floor above the unit. �No drawbacks that I can see other than some audio quality loss at louder volumes. �Highly recommend.