Radio Shack Car Phone Holder

I use it in the car to connect the phone to the radio, very good product.

I use it to switch speakers and/or different radios in my Ham Radio Shack.

We had a old mic that was dropped and needed to be replaced at our church and this worked well for that. It's better than the old Radio Shack mic it replaced.

I've been buying these for decades...since they were sold under the Radio Shack branding. They sound just the same today. Also bought some new foam ear pads for some of my older ones. They fit perfectly.

I would hop into the car, but never found right spot for phone. I would put phone on car dash shelf, drive around a corner, not speeding mind you, and phone would fly across car, or end up under seat or down side of seat or wherever! There would always be that annoying charger cord getting tangled and in the way and usually ends up broken. But now….hop in car, easily place phone on holder - it stays there no matter how many potholes I drive over and…..the best part…..it charges on holder! The cord is concealed with little clips so no more annoying cords in the way. Absolutely love it! And because it is a permanent fixture, it counts as handsfree.

I stopped in at a Radio Shack store and they did not have this part. However, the clerk looked online and found this part through B and H. The clerk gave me the web address and the part number and I ordered it right then. It was delivered the next week. It was exactly what I needed. And the price is reasonable.

Needed this to extend my Aputure A.Lav to reach my camera mounted Zoom H6 for recording interviews. I also used the Kopul XLR Male to Mini Female Adapter. It works well with much less noise than I was having with radio shack stereo mini cables (radio shack cables would hiss and hum unless I was holding it in my hand just right!). I also use this as an extension for my headphone monitoring.

Nice solid speaker mount. Used it to mount some old radio shack minimus-7 speakers on the kitchen wall. They are die cast metal so are fairly heavy. I did built a wooden adapter for a solid connection. Hate it when things wobble.

Much better picture than using VCR for modulator and Radio Shack RF switcher. No lines much better picture. I only use Blonder-Tongue for modulators.

Using the ATR1300 with a Radio Shack stand together with a Heil HS-1 PTT switch on a Yaesu FT-950 Amateur Radio transceiver with excellent results - especially on the wide audio frequency response settings (100-3000 Hz and 100-2900 Hz). Using only the '950's built in equalizer - no need for external components in the audio chain. Compared with a Heil PRO Set Elite, the ATR1300 wins hands down and costs a fraction of the price. Best $ I ever spent on any audio equipment !