Rca Digital Flat Outdoor Antenna Reviews

This worked as i needed to mount antenna to a flat lip surface

I used a pair of Catapult (TX + RX) to replace some long RCA cables. Not only does the flat CAT5 cable take up less space under the carpet, but now there is less hum and buzz because the balanced outputs can be used.

Amazing flexibility. I'm using a single CDI 1000 amp to run a string mono of 70v outdoor speakers AND a massive outdoor 8ohm sub. Plenty of power but the magic is in the DSP chip that allows you to EQ and cross over the amp however you desire. When I first installed, the default internal crossovers were used and then I hooked up a laptop with the free Crown System Architect Software and then--WOW. After every thing was EQ'd and the crossover tweaked it's like listening to live outdoor music which is exaxtly what I was going for. *Note that the amp is designed to use balanced XLR inputs so you will lose 6db with an unbalanced RCA siganl or you can use a Pro Match to convert RCA--XLR and regain full output*

Works great with Neumann KH150 speakers for digital i/o (I had some RCA cables that didn't work or had digital problems like popping but this cable worked.

This cable is great for connecting many types of gear you may not have considered before. I use it to connect my digital recorder (which only has RCA outputs) to my studio monitors. Very high quality connectors.

We wanted to extend our Stereo system to other parts of the house, and after some research, I settled on this BT device. I'm using the BTA30 on the zone 2 (RCA analog) output of an Onkyo TX-8555 receiver to transmit to bluetooth enabled speakers and sound bars around the house. Since the Onkyo does not have digital audio out, I used an analog to digital audio converter** to go from the RCA output on the receiver to the digital TOSLINK input on the BTA30. Setup was simple and straightforward, just remember that the BTA30 has a volume knob, so remember to turn it at least halfway - i had left it all the way down and was trouble shooting for several minutes until I noticed the knob position - turned it up and it worked! I am experiencing a wee bit of latency if I'm listening to the same music in both zones at the same time, but that's most likely because the speakers I'm transmitting to are not APTX capable. In all, it's not that big of an issue, just something to be aware of. Overall, I'm extremely satisfied with the BTA30 - and the B&H shopping and shipping experience is second to none! **If you don't have a digital output available, you will need an analog to digital audio converter that accepts RCA audio inputs and digital TOSLINK output. You could use the BH #GEATVDA to accomplish this.

Purchased to convert old Handycam video8 tapes via rca jacks to digital. Easy and provided better images than other similar converters I've tried. Recommended for vcr or tape Camcorder to digital.

I have used a Winegard Flat Wave antenna with amplifier for several years, but recently been getting lots of interference on several cannels. I purchased a Winegard Elite 7550 Amplified Antenna in hopes of eliminating the interference. It Worked! No more interference! I don't get anymore channels, but I was already getting all the channels in my area. It was easy to assemble and install with a well built and versatile mount.

[This review was collected as part of a promotion.] Greasy outdoor TV antenna. Very impressed.Great design, super study and very easy to install. Straight forward directions. Overall excellent quality and produces a great picture. Very pleased with this purchase.

I have two of these installed. One in my car, and one set up as a base station at my house with an outdoor antenna. Great range, and I'm able to keep in touch with my daughter when she's out and about in the neighborhood using a little HT. I already have a third radio on the way for a second vehicle.