Rca Output To Computer Speakers

We wanted to extend our Stereo system to other parts of the house, and after some research, I settled on this BT device. I'm using the BTA30 on the zone 2 (RCA analog) output of an Onkyo TX-8555 receiver to transmit to bluetooth enabled speakers and sound bars around the house. Since the Onkyo does not have digital audio out, I used an analog to digital audio converter** to go from the RCA output on the receiver to the digital TOSLINK input on the BTA30. Setup was simple and straightforward, just remember that the BTA30 has a volume knob, so remember to turn it at least halfway - i had left it all the way down and was trouble shooting for several minutes until I noticed the knob position - turned it up and it worked! I am experiencing a wee bit of latency if I'm listening to the same music in both zones at the same time, but that's most likely because the speakers I'm transmitting to are not APTX capable. In all, it's not that big of an issue, just something to be aware of. Overall, I'm extremely satisfied with the BTA30 - and the B&H shopping and shipping experience is second to none! **If you don't have a digital output available, you will need an analog to digital audio converter that accepts RCA audio inputs and digital TOSLINK output. You could use the BH #GEATVDA to accomplish this.

I use this Y-cable for connecting two audio cords (from my desktop speakers) to my computer which only has one stereo output. It is great and I have not found any flaws. I will see how it will hold up in the long run.

I use this to switch computer sound card output between PC speakers and stereo amplifier. Works great.

Im using the Rolls MB15b simply to boost the output of a consumer level device that has stereo RCA outputs. So, on the Rolls both input and output are via RCA, but the adjustable output level can be made significantly higher than what Im inputting to the Rolls. Works great and the sound is clean with no additional background noise that I can detect.

This A/B switcher is exactly what I was looking for. It's a no frills passive RCA switch that allows you to switch between two outputs and one input or two inputs and one output, depending on what you're looking for. It's small, lightweight, and with robust build quality. The only problem is that it's a bit expensive for an essentially simple piece of technology.

I bought two fto conect Dynaudio powered monitors (XLR inputs) to a RCA output preamp. SQ is excellent; there's no hum, and the pin-out was correct! I bought other RCA-to-XLR cables from a big online company & had to tearrange/resolder the pins to get signal.

Works great for us. Using the SlingStudio HDMI out to this and converting to RCA to output for our campus TV system.

We are using this mixer to switch between a crowd microphone for singing in our church with the main output which comes to us from RCA in the sound board. The box is steel and very rugged. Knobs are easy to control. Solid equipment. Only problem I had was moving the little switch for the phantom power. The tiny piece of plastic ended up going inside the container and I had to remove the case to get it back.

Works Very well. I needed to place between my( Pro Gear) Behringer Mixer XLR output to my (Consumer Gear) amplifier RCA input. Turned the needle to 1/3 way up and awesome sound from my speakers. No more noises! Awesome product. I am using for karaoke. The Clean Box Pro is excellent in converting from my mixer XLR output to the amplifier RCA input.

Using these RCA cables for the output of a Pioneer mixer and like good cables, they are out of sight and out of mind. I've used them at home and a few gigs and have had no issues with signal loss or diminished quality. Recommended.