Refrigerator Trips Gfci In Garage

The battery works very well with my Delta 2. I am using these to run my refrigerator and freezer in my garage. I have installed fixed solar panels that have so far provided enough power to work for most of the day. The automation features and reserve power settings are very useful. I have already been able to use the units to power my refrigerators during a power outage. Great combination.

I purchased the EcoFlow Delta 2 to power my CPAP machine for camping trips and to power CPAP and refrigerator during power loss at our house. We had good success with the Delta 2 camping to power my CPAP for two nights including lighting and phone charging. We had a 5 hour power loss in December of 2022 and the Delta 2 was able to power the refrigerator along with Keurig coffee maker and microwave to prepare breakfast and lunch. I also purchased the bifacial solar panels and have recharged the Delta 2 with the panels located along a south facing wall. If we have an extended power loss during a snow or severe weather event, I have a small tailgating generator to run periodically during the day to recharge the Delta 2 for day use while it is running appliances since it has pass through capability and then transition to Delta 2 only at night to power CPAP and refrigerator while sleeping. Solar panels would be used for extended camping trips or extended power loss at house if generator runs out of gas or breaks down.

our refrigerator is covered with them!

Have a high end refrigerator that is plug in into it, so far so good!

Even better than promised. Will try hooking it to my refrigerator.

Strong enough to hold up a refrigerator, I think. Fits perfectly, of course.

I change my review to a four. The issue with the error pertains to amount of power required at start-up. If the power is too great, just as those associated with hair dryers, the circuit (GFCI) will trip/default. It has been my experience that the power socket/outlet can not interface with a GFCI receptacle. Furthermore, some batteries lack the necessary power/amps required at start-up. The solution is to use a strong battery source and/or circuit not connected to a GFCI. This information should be printed on the material. Bottomline: these are great strobes if powered from a source that can handle to amp, without disruption at start-up. The strobe will work flawless afterwards.

This series of cyber power UPS is the only model that doesn't have leakage current to trigger the GFCI (ground-fault circuit interrupter) outlets. It has power factor ~ 1.0 (1000VA/1000W). Very impressive.

Connected to my River, kept my portable refrigerator going all weekend

I works very well with my wine refrigerator and also has outlet for my ethernet cable to make everything seamless.