Reolink 5Mp Poe Security Camera System

Works great for my Reolink PoE security camera. Output meets its specs and so far no issues. Runs very cool, smaller than usual PoE injectors I have and at an incredible price. Even comes with a wall mount and nice design that looks more like an ikea power adapter than a bulky utilitarian looking. Check if output meets your requirements and buy if yes.

I am using this PoE for a home security system with Vivotek IP8335H 720P HD Cameras. It was very esatly to install, just hooked up the network from my 4 port router to port 8 of the switch, and attached my 4 cameras to the 4 ports that supply PoE and off I went!! It has a total of 8 ports, however 1 port must be used to supply the network to the unit, then there are 4 with PoE capability and that leaves 3 regular ethernet ports. Nice switch for the price. So far I havent found any fault with this item.

Used for POE security cameras, which worked great!

I can't say enough good about this little switch. It offers per power management for data and power use. Yes you can order it to power cycle any particular port to reset those hard to reach AP's or cameras. It measures the PoE consumption of each port as well as the total draw from the PoE uplink. It's sealed against weather and mounts in harsh environments like attics and garages. Integrated into the UI software it's also helpful to track down problems with devices connected through it. If you have a router, you can also run VLANs through it to, for example, tap off a dedicated PoE ethernet line for a security camera and turn it into a general purpose trunk line for regular devices like solar inverters or AP's, and then VLAN the camera port back to the dedicated port on the NVR for added security.

We added a fifth camera to our security system. The camera was perfect and was exactly what we wanted and needed.

This Category 6 cable worked great for me when running it for 8 POE 2k security cameras.

I can't say much as it's just a cable. It's is well built and works. I used to pull a line through my attic for the camera system on a PoE switch and I'm very happy with it. B&H had the best deal to boot!

I purchased this POE switch for a camera system. There are 4 cameras that are connected to a NVR thru an access point (bridge mode). I used this to power the cameras and feed the antenna. The switch has a 48vdc power supply. Works like a charm.

Works great plus ties into our existing Lorex POE camera system. It would be even better if you could add your own personalized chime to the many chimes built in.

Very good camera. Now need to get the whole set to complete my security system