Reset Computer To Factory Settings Windows 10

...once I figured it out. It needed to be reset to factory settings, but once done, all works as---or better than---expected. THANKS

Using Sonos for over 8 years never had one wear out. I've had to reset a couple back to factory settings but always get them working.

Love this monitor but the only negative is I cannot change the contrast because of the factory HDR settings. The windows task bar is a little gray vs black for my liking. Have not found a way to adjust it. The setting is disabled.

failed first install did a factory reset everything is fine

I could not upgrade the firmware from Godox through my windows 10. So after a computer professional looked over the situation said that Windows 10 would not recognize the upgrade due to the time Godox wrote the firmware upgrade. He used Windows 7 and the firmware upgrade worked.

Works perfectly out of headphone jack on windows 10 computer

Great for backing up files. It worked on a Windows 11 and Windows 10 computer.

I used it as a second drive for Windows 10 on my Ubuntu computer. There were no problems with the drive itself

I bought these for our company to do at home recorded videos on their laptops with better audio quality than the built in laptop microphone. I just tested it and compared it to the laptop mic and there is a very noticeable increase in quality when using the usb lav. At first it was way too over modulated but then I realized I needed to tweak the mic settings in windows 10. First, plug it in and let it download the drivers automatically. Then, type the word sound in the windows 10 search bar and click sound settings. In there, go to the microphone area and make sure the usb lav is the active one selected. Once it is, click on device properties and in that menu adjust the volume slider until you have a proper microphone level that isn't topping out too much to the right on the sound level bar. I put mine around 40-50 but it depends on how close the mic is to you mouth.

Good modem...a little difficult to setup (must reboot several times, and set to factory reset a couple of times) to obtain the IP address. Once that is obtained, then just works.