Run Cat6 Ethernet Cable Outside

I like the white cat6 cable.

Worked as advertised. Used for a live concert with a 50 ft run of cat6 cable. Plug and play, no issues. No signal loss or latency issues. Highly recommend

I've been using these weekly in a church setting for 4 years now in a 250 foot CAT6 cable run, and they have been completely solid. I bought these at the recommendation of an A/V consultant to replace some converters that often cut out, and I have been fully satisfied.

I used this to run VGA over cat6. It worked great once I took the time to do a few little adjustments.

Just moved into a new construction house where the builder didn't think to run ethernet to every room. He did, however, run coax. Although I have zero intention of getting cable tv, it looks as if these will run cable box/tv coax pass through. I just had fiber installed in the basement, and ran out from the fiber router via ethernet to one of these, then plugged that into the coax that runs to my living room. I put the other MoCA adapter in the living room, plugged it into a 5 port switch which is connected to my SmartTV and PS4. Within 15 mins, I'm streaming 4K on my new tv, while having a rock solid connection speed on my PS4, and not noticing any load impact on my wireless network. Works like a charm. If you unplug ethernet devices, you may want to power cycle the receiving unit, in order to get a fresh IP.

Could not run a Ethernet cable to office it was impossible climbing in the attic was not feasible. PLP 2000 did the job .

Used this switch in an outdoor location. This PoE powered switch makes it so convenient to run just one ethernet cable for both power and data.

Could not run a Ethernet cable to office it was impossible climbing in the attic was no feasible. PLP 2000 did the job .

This is the cheapest SFP+ switch (but reliable) I could find for my homelab. Many others are more expensive. After reading reviews on the Mikrotik SFP+ options I decided to stay with Unifi since I already had many Ubiquiti Ethernet switches and a controller in place. I am also connecting this to a Unifi 24-port via 1-Gb SFP as a link and connecting to my core switch via 10GbE over CAT6. Core switch is an FS.COM unit with a 10GbE Ethernet transceiver. No issues negotiating to 10GbE. The CAT6 cable run is probably under 50 feet. I am also using old Finisar transceivers without issue, but have not tried DAC cables yet. However, if you do not have a Unifi Controller in place perhaps wait for the new QNAP managed combo switches coming out. It will be a lot simpler. Or you can get the more expensive EdgeSwitch ES-16-XG.

Not much to say about an ethernet cable, except that it works.