Samsung 3D Glasses Battery Cr2032

I am currently using this case to store 4 pairs of Samsung 3D glasses. I know, overkill, but buying a cheap case to put them in cost more than this and laying them around the coffee table was not an option. Very protective. Well made. Made in USA. Inside foam can be re-ordered so it can be configured for other items in the future. The only downside to me would be a cheaper price, but this one was priced well.

I run through a bunch of CR2032 batteries every couple of months. I like these because battery life has been good, and I can buy them at a reasonable price through B&H.

The RAYOVAC CR2032 Lithium Battery (2-Pack) contained two, count-em two CR2032 cells. Absolutely amazing!!. These were purchased as spares, so I have not measured their voltage yet. Presumably, they will produce the rated 3 Volts and will last for 190 to 240 mAh. They are 20 mm in diameter, shiny and light weight and most likely contains some lithium & manganese dioxide so are technically a LiMn02 cells. FYI: They can explode if heated to more than 80 deg. C.

Used for looking at targets in 3D archery shoots. Easy to carry and easy to use, even with glasses. I'm very happy with my purchase. No problems here.

Needed an eyecup to be able to use the viewfinder of a Leica Disto distance meter with glasses. 3D printed an adapter and... voila!

I did my homework and decided on the Samsung SSD 850 Pro because of the new 3D vertical NAND (V-NAND) flash memory, top performance and high endurance. I believe the extra monies spent will be well worth it. Installed with no problem and up and running. I replaced a WD VelociRaptor that was having problems.

If there was any doubt about whether I like this monitor, it should be dispelled by the fact that this is the third Samsung UR59C monitor I've purchased. I'm using them on three computers. I use them for programming, electronic design (schematic capture and PCB layout), 3D modeling, as well as the usual office applications, email, etc. A curved monitor does take a little bit of getting used to for CAD and 3D modeling.

I wanted to be sure I had more than enough power going into my Delta Pro and Extra Pro Battery, especially if I am on the move or need to power my 3D printers for an outdoor event. Leaving the panel out in prime sunlight made it charge the batteries as I was 3D Printing. This means I was 3D Printing with ZERO CARBON EMISION! That's amazing!! I'm seriously considering making my whole business run on ECOFLOW Batteries and Solar Panels from this one experience alone.

Battery is used as last resort when Samsung BP-1900 dies.

We love movies and don't go to brick and mortar theaters anymore for a number of reasons. We have been using home projection for over 6 years now and our first projector of choice was Epson PowerLite 1450 which we loved. Unfortunately. it had to be replaced. After studying what is now available we went with Home Cinema 3800. It is slightly larger and heavier, but we don't intend to move it around (We have a smaller more portable Epson Projector as well - EX 7230). The 3800 has 3,000 lumens of brightness while the 1450 had 4200. There wasn't an alternate that was in our acceptable price range. On the positive side, it has an outstanding picture quality and also can show 3D movies which we promptly purchased the required 3d glasses. We already own a 3d Blu-ray player . It has been fun watching the Hobbit, Avatar, and Top Gun Maverick in 3D. Very exciting. The 3800 is quieter which is important because it is positioned very close to us. For sound, we don't rely on its two speakers because we've always plugged it into our Soundbar system and receive great sound! So we are able to stream movies and TV ate our 100 inch screen.