Screws For Projector Screen

I purchased this unit to mount an ultra-short throw projector on our stage electrical rigging for projected scenery in a musical. With this type of projector a fraction of an inch adjustment on the projector means inches on the screen so precision is paramount. The gear driven adjustments made aligning the image on the screen fast, easy, accurate and reliable. The mechanics are firm, not so tight that adjustment becomes jumpy, not loose enough to wiggle even the slightest bit. I mounted the unit on a pipe attached to our light rigging that is brought in and out frequently. After the initial installation, I never had to re-adjust as a result of the rigging going up and down and stopping suddenly at trim points, and my projections were always perfectly aligned to the sccreen I have used other mounts where you loosen a couple screws, move the projector by hand, then hold everything in place while tightening down the screws and there is no comparison. There's no need to try and compensate for the effects of gravity when you let go of the projector. The image you see while adjusting is the image you'll have after you've climbed down the ladder. All this and a similar if not lower price and there's no reason to go with any other system.

We use this projector screen in our church activities.

I installed them next to my projector screen and they sound great.

Anyone looking to extend there monitor onto a TV screen or projector this is the way to go.

This product is easily installed into your projector by removing 3 screws. It is very light weight

Using this to decode an NDI source to a projector in Church services with live stream. We previously were sending the Presentation Laptops screen to the OBS computer via NDI, and used a separate proprietary wireless video feed to the main projector. Got this so we can use the same NDI source for both and eliminate the wireless projector feed. It is working well. One thing to be aware of: the projector will display will go blank in a couple of seconds if there is no video and audio activity when using NDI Screen Capture as the source. This can be an issue during power points with static screens. You can set the decoder to keep the last thing displayed on the screen or allow it to go blank. I prefer it to go blank so I know something is wrong right away. You can also resolve by making sure the NDI Screen Capture is using an active audio source (like the microphone). This decoder has been reliable and is reasonably priced. Perhaps other decoders won't have the inactivity issue but they are also more expensive. This has not been a show stopper for us.

After finding this unit we have tried to use it exclusively when possible. No more holding a projector while tighting mulitple screws to hold it in place; only to find it move when you let go. With this unit you simply turn the adjustment knobs (...with your fingers!) and your done....sweet!!!

Arrived very well packaged. Comes with mounting screws. Easy install and my projector is back in action. This is the same bulb that comes with the projector from the factory.

I use this product to install my Optoma HD-20 projector on the ceiling of my living room . I'm VERY satisfy ! Everything in the package was present , from the mounting equipement to all of the size of screws available for installtion. In my case I used the 8.5 mm screws . GREAT product Thanks Jeff

It's strong and black. The mounting hardware is not appropriate for holding the weight of the column, mount, and projector. They supplied large plastic Sheetrock anchors and screws. This should be attached to a ceiling joist! The hardware was not right for doing this. I had to buy 3/8 x 2 lag screws and washers, then paint them black after they were installed.