Spark Plug For Craftsman Pressure Washer

If you haven't noticed in the pictures, there are two foam trays. So the case is almost twice the height of other cases. All items the cutouts are designed for fit snugly. The cutout for the Spark is deep enough so that the props are below the top of the foam. This means the egg crate foam in the lid will not put undue pressure on the props when the case is closed. The full fly more package will easily fit plus an OTG cable and other accessories. There is a rubber gasket around the lid and a raised ridge around the top of the base. These two come into contact when closed to create a watertight seal. There is also a pressure equalization valve as well. When you open the case there is a detent to keep the lid open. The only hit I have is the foam bottom for the top tray may split in high use cases. The bottom foam is only about 4-5mm thick. Should this happen or to prevent from happening you could apply some gaffer tape under the controller and Spark to reinforce the foam. So far there are no indications this mod is needed In the three months I have been using the case I have had no issues with it. It’s nice to be able to fit the Spark/Remote Controller/Charger and Hub/Prop Guards/Accessories in just one case you can quickly grab and go. All in all I would say this is one the best hard cases for the Spark when basing it on price and value.

We use this product on industrial 110V pressure washers. All the new units have the 20 amp plug on them and we rarely have access to those outlets. We used to go to an electrical supply and buy components and make our own pigtail converter. This set up is MUCH easier and cheaper.

Someone please tell me any other film washer better than this.

Works very will and makes the Spark much easer to operate

I have tried many holders and this one is the best in craftsman, durability, ease of use and reliability. Easily secures my iPhone X Max with no issues

This arm is an incredibly solid -- it feels weighty and craftsman-like. I purchased the arm to hold my 34 LG ultra-wide monitor, but it's obvious that the arm could have even held much larger monitors or TVs without issue. I was worried that the weight would be too much to clamp the arm to my desk, but it's not a problem at all because the clamp is incredibly secure.

A very pressure product exactly as I want

If you have a Tricaster, these are the way to go! We have both Birddog converters and Spark I/O's, and the Spark I/O's always sync on a boot up where as the birddogs do not.

What a wonderful tool to spark creativity for a burned out photographer!

This fits everything as advertised. Super sturdy and keeps everything safe. A must for any travel with the spark.