Spark Plug Getting Too Hot In Pressure Washer

If you haven't noticed in the pictures, there are two foam trays. So the case is almost twice the height of other cases. All items the cutouts are designed for fit snugly. The cutout for the Spark is deep enough so that the props are below the top of the foam. This means the egg crate foam in the lid will not put undue pressure on the props when the case is closed. The full fly more package will easily fit plus an OTG cable and other accessories. There is a rubber gasket around the lid and a raised ridge around the top of the base. These two come into contact when closed to create a watertight seal. There is also a pressure equalization valve as well. When you open the case there is a detent to keep the lid open. The only hit I have is the foam bottom for the top tray may split in high use cases. The bottom foam is only about 4-5mm thick. Should this happen or to prevent from happening you could apply some gaffer tape under the controller and Spark to reinforce the foam. So far there are no indications this mod is needed In the three months I have been using the case I have had no issues with it. It’s nice to be able to fit the Spark/Remote Controller/Charger and Hub/Prop Guards/Accessories in just one case you can quickly grab and go. All in all I would say this is one the best hard cases for the Spark when basing it on price and value.

Plug it in, but be sure you are powered down when doing so, it is not Hot Swappable

Its great. Doesnt run hot at all if you arent overclocking and just gaming. Getting 60s with Dark Rock Pro 4 under gaming load, 30 and below when idle.

We use this product on industrial 110V pressure washers. All the new units have the 20 amp plug on them and we rarely have access to those outlets. We used to go to an electrical supply and buy components and make our own pigtail converter. This set up is MUCH easier and cheaper.

Someone please tell me any other film washer better than this.

Getting a second one.

Works very will and makes the Spark much easer to operate

Too expensive!

Too expensive.

Couldn't be happier. Works as designed. Plug receiver into camera..turn on, and your ready to go. Have only had for 2 weeks, but no problems so far. Receiver fits on hot shoe or simply attach to camera or tripod. Doesn't use hot shoe, only a place to rest. Remote has 4 modes of shooting. Flip the slider and push the button. Happy ...and much cheaper than Nikon's.