Spectrum Router Connect Ip

This is a fantastic Access Point. You still need a router so this device can allow clients to connect and assign them an IP. Netgear insight portal is convenient and easy to use. Highly recommend it.

This router is a great router combo at an affordable cost. Works well with Spectrum!

This was easy to use and connect to a IP camera set up. Receives sound good.

I upgraded my router from spectrum base model to this lovely nighthawk.. I was noticing lagging and traffic usage was slowing my spectrum router down.. the nighthawk router help my speeds by 200 mps but lowered my ping and can use all my devices without lag spikes! Most get in modem and routers

[This review was collected as part of a promotion.] I recently switched to this router because the one I had kept switching my ip address. My internet would go out and equipment would not work. I'm glad I switched.

The router was easy to setup after creating an account. The instructions manual which was downloaded from the site was handy, but really not needed for the setup. The setup was easy due to the on-screen information and easy to fill fields. This router is connected to my carrier's gateway using the IP pass-through method, thus it assigned a WAN IP to the router so I could create a separate network. The Asus RT-AX88U Pro is powerful. It covered more square footage with higher signal levels than the gateway installed by my carrier. I love its enhanced security features, which are standard and at no additional cost to the user, unlike other router manufacturers that charge a fee for such services. This is an outstanding router and highly recommended. It delivers the features and performance as advertised and seen in online reviews.

Very easy install. Self registers on Comcast. Pass through IP to router. Increased download over 25% compared to Comcast X1 modem.

Using this with NEC NP-M352WS 3500-Lumen Portable Short Throw DLP Projector. Powerpoint slides are about 1 second delayed. No audio via the wireless adapter. However, I am happy with the device for my purposes. I also use a hard wire for audio/video usage. After the second round of ordering, receiving, and returning the first order of the projector and this adapter, an with level II NEC tech support, I am finally able to get the devices to work together. Also, I am not going to be using this on a wireless network/router, but through the Easy Connection option (no router present at installation). It came down to one simple operation (from Mac OS 6.8): Before starting the process below, you will need to get the wireless IP address of the projector. Mine was 10.0.39.155. -click on the wireless icon at the top of the screen -click on Open Network Preferences -click on Advanced -click on TCP/IP tab -change the Configure IPv4 setting to Manually -change the IPv4 Address: to something close to your video projector's (my instance: 10.0.39.160) -click OK and then Apply Don't forget to reverse this setting when you're done using the wireless adapter in order to connect to the internet normally. Hope this helps.

I used this to connect my iMac to my router...works great!

I have a wifi only laptop that I wanted to use to test a newly purchased IP camera on. The adapter allowed me to connect a ethernet cable to my IP camera for testing. After giving the adapter a IP address in the same range as the camera my system connect with the camera perfectly. I would highly recommend this adapter for anyone needing to add ethernet wired access to there wifi laptop.