Spectrum Wireless Router Power Cord

Finally, a wireless system that works without the hiccups of switching. Disconnected my Spectrum router and replaced it with these. covers 3000 sqft house - and covers a pretty large area outside. 2 are wired direct and the third is wireless. A little quirky to get the first one set up but any additional are just plug and play.

It's a must have upgrade router in keeping you in the forefront of wireless power that Synology does so well especially for their well know NAS.

This router is a great router combo at an affordable cost. Works well with Spectrum!

I purchased this case to house a 3U Mackie DL32R audio interface/recorder and it is perfect for this application.  I mounted a wireless router on top of the Mackie and also mounted a power strip in the rear to power the Mackie and the router.   I then routed the power strip power cord from the rear up through the unused 1U area.  When in use, I keep the rear cover on  and position the unit vertically on the rear cover.  I remove the cover on the top end and pull out the power cord plug  end and plug it into an outlet to power the Mackie and router.   This also allows access to the I/O connectors on the front panel of the Mackie.  When finished, I tuck the power cord inside the spare 1U area, replace the top cover, and wheel it away.

I use this to provide backup power for my satellite internet, wireless router and VOIP phone system. Occasionally, it also powers my laptop and external LCD. Works great and has more than ample reserves. Functions out of the box with Apple Macs and seemlessly integrates with Energy Saver in OS X via the included USB cable. No Cons so far.

I bought this AP and a related router to replace an aging consumer grade wireless router which I had. Setting up this AP was a breeze and I'd recommend this to anyone wishing to implement or extend a wireless network in their home or small office. The thing to keep in mind is that this is intended to be mounted on a wall or preferably a ceiling. The router only requires a network cable and you use the included power injector to power the unit. This AP will require some other device to route the traffic from your web provider. Configuration is easy with the Unify controller software installed on your pc. Wait for the AP to power on, load the software on your pc (on the same wired network), and let it look for and provision the AP. You can configure a single combined SSID for 2.4 and 5ghz or separate and configure a guest network if so desired. Once configured, the AP has been running without issue solidly for a few weeks now. I have my PoE injector in my office and plugged into my UPS along with my modem, router, and switch. If the power goes out, all of the wireless and internet access will stay up. Be sure to test all your ethernet cables prior to installing everything. I had multiple issues with the cables I was going to use initially. One cable would only allow a max 100 connection, the other would allow gigabit, but the rj45 connector was able to pull back just enough while connected to cause an intermittent connection. Swapping to higher quality cables solved these issues. I have a 3800 sq ft house in an L shape. This AP is on the second floor in the center of the house. This works well for coverage everywhere and I've even seen coverage in areas where I had little to none previously. I've got it mounted in the ceiling of a hallway next to a smoke detector. It doesn't look too out of place except for the blue glow (which can be turned off). I'd recommend this to anyone that has basic networking and computer knowledge looking for a solid access point.

Amazing power cord!

It's a power cord, and it works.

I upgraded my router from spectrum base model to this lovely nighthawk.. I was noticing lagging and traffic usage was slowing my spectrum router down.. the nighthawk router help my speeds by 200 mps but lowered my ping and can use all my devices without lag spikes! Most get in modem and routers

Great switch from the standard router you would rent from Spectrum. Was having issues connecting 2.4ghz devices to the basic router from them. Bought this and didn’t realize how slow my WIFI was with their router. With the AX4200 my wifi speed is amazing, videos stream better than ever, gaming is much easier and I can now connect my Roomba to my wifi. No complaints so far! Their NETGEAR app also has a ton of features, albeit many that I might not use. However, it is nice to have those options! Thank you!