Stick Extender 3D Print

you may need a USB extender depending upon where your USB port is located (since the recorder has a retractable one, the butt of the recorder may prevent you from actually being able to stick it in - for USB ports located on the side of the monitor)

Pros: Easy to use; refill filament, print 3D files, wireless is convenient, and non heating bed. A great value for a 3D Printer. Cons; purchasing expensive filament through XYZPRINTING. Not able to purchase 3rd party filament due to NFC chip.

This is my second 3d printer. It is a fabulous printer the build size is limiting. The performance and print quality are spectacular. Very quiet also.

Love it. Easy to use; decent print quality. This is my first 3D printer and I am totally new to 3D printing. Glad I bought this as my first one as entry level.

The 3D40 Flex 3D print is my first 3D printer. It was easy to set up and bed leveling was extremely easy even for a beginner. It can be connected to the computer with WIFI, USB, or Ethernet. The flexible table makes part removal easy. I've used this printer more than I thought I would before I purchased it. I've been able to create things easily using free software. Dremel provides free slicing software, but I did opt to purchase Simply 3D, which has built-in defaults for my printer. My daughter now calls me a Craft Geek.

My first 3D printer and I love it. The instructions are clear and it is easy to assemble out of the box. There are a ton of youtube videos on this printer so this has helped me a lot. What I found most valuable is to make sure you FIRST mechanically flatten the bed and then do the auto-leveling. I do an auto-leveling before each print because every time I remove a previous print I fear it moves the adjustment. Remember we are printing ~0.12-0.2mm layer heights so I think it is important to auto-level each time. It only takes a minute or two. Also do it with the bed and nozzle at the temperature you are going to print at.

I was going to 3D print a cover for my lens but I saw this and decided to try it. I am glad I did. It is great to protect the lens on my Osmo Action.

So this was my 1st 3d printer I had done my research for quite a while if you want a premium printer that can print right out the box with minimal setup and a large bed this one is for you I might just buy a second one too.

Since entering the 3d print world I wanted to have some flexibility and ability to use a array of filaments including carbon fiber, and thought the quick cooling of the hyper pla would work for me. Test and prints came out looking great and the prints all feel hardend and sturdy, which is great for what I intend to print. Definitely gonna be my go to until I begin carbon fiber testing. Ohhh and as always B&H taking care of you with the high level service. Packaging was great and shipping was speedy. Bravo

Well I like the design cameras camera+print+stick it’s amazing makes me want to buy it.