Storage Drawers Emitters

These drawers work great for storage on rack systems and are quite a bit less expensive than other similar models. I've got 10 of these now and will continue to use them to outfit my studio and mobile trailer. ...

I have 4 of these. They took the place of random storage in plastic bags and the bottom of drawers. I like them because they are waterproof and secure, yet easy to open without breaking a fingernail, unlike some other competitors. Not expensive and highly recommended.

Great card storage device! I was always searching through desk drawers and camera bags for lost cards. But no more!

These are just perfect for me for moving slides from trays to a much more compact yet searchable storage that can go in either file drawers or binders.

I bought this to control 8 identical IR devices in a "new configuration" setup. (I have 2000 of these devices to load software onto) When I setup the devices and positioned the IR emitters on the devices, I only got a few correct commands sent to the 8 devices. I "thought " the problem was not enough signal to the IR emitters on the devices. It turned out that the controlling handheld IR Remote was sending TOO MUCH signal to the IR Receiver, distorting the output signal through the repeater. I found some colored cellophane (flood light gel filters, if you are familiar with those), and was able to use a dark "neutral density" filter BLOCKING 90% of the light, and a red filter blocking everything below 700nm. I taped those over the RECEIVER pickup, and "VIOLA", the 8 devices responded perfectly. So if you get intermittent control, try adding just a few pieces of satin scotch tape to the RECEIVER sensor to see if the control gets better. I was up to 5 pieces of tape with marginal improvement before I tried the colored and ND filters, and then had a repeatable solution.

Added this for my License Plate Camera and it is better than expected with a focused high intensity IR light that reflects off of plates making all plates at night easily readable. See attached photos and note emitters are red and visible just hard to photograph. Also have 2 other Axton IR emitters for the front yard that replaced some cheap IR emitters. The difference in coverage, distance and even spread is night and day.

Exactly what I needed for lighting up backstage rack drawers. Just as described.

I use them to secure drawers on my work bench, one combination easy access.

I have hundreds of DVD's and I can store and organize an amazing number of discs in drawers.

The rip tie was perfect for organizing all of the loose cables that i had in my desk drawers.