Strip Ethernet For Ground Wire

I installed it myself. It was quite easy if you have the Ethernet wire available. I get great coverage now in the area that was week.

This ethernet adapter works with Roku Streambar and you can just add hard wire connection and it works right away after hooked up. No setting required. Besides Roku, it works with most Android devices (with USB C PD passthrough hub) and Windows. It's basic, but it's pretty good due to perfect compatibility

I was looking for a router with mesh points to get read of those no service areas in my town house. I have always had to an Ethernet wire from the downstairs to my Xbox upstairs in order to have good connection. I now no longer need to do this ever since setting up this router. I could not recommend this enough. Connectivity is excellent !

This wire is better than all my other ethernet wires. I like that this wire is much thinner hence easier to put in corners. It does tend to coil but I suppose every wire has that problem. Had no connection issues with this wire.

We're using these adapters to run ethernet and POE to Unifi G3 Flex cameras in our condo's elevators. The cars have 18 gauge stranded wire pairs in the travelers, so we tested with speaker wire before having the elevator techs handle the connection to the traveler. Setup was quick and easy. Worked instantly and flawlessly.

1000 feet is more ethernet cable than I am going to be able to go through in a decade. I guess I could go ahead and wire up my entire house. At the price, it is the way to go for any extended runs because you just can't beat the price per foot with ready-to-go cables. And adding your own connections is not that hard with the right tools.

I bought this after the wire on my Rode VideoMic Pro got a short from a very small drop to the ground. The wire on the Rode is a fatal flaw of that mic. The MKE600 is just a little more money, and it is far superior and more versatile. The hotshoe camera mount (included) works great too, but get the rubber support if you want to use a boompole. The MKE600 is the best value for low budget film makers right now.

The Pyle preamp worked great. You need to ground the preamp and turntable to the amplifier to prevent a hum. This can be easily done by loosening a screw on the amplifier and attaching a wire to this screw. Then attach this wire along with the ground wire from the turntable to the Pyle preamp ground screw. Then tighten all ground wires to their components.

Installation of the Pyle Pro preamplifier was very easy to figure out- - plugs in, attach the ground wire, and ready to go.� Works nicely!

Ethernet cables are ethernet cables, but these are fine!