Swamp Cooler Electrical Box Wiring

Just needed a replacement cord for my Bonaire swamp cooler. Couldn't find one anywhere else! Good price, and it arrived very quickly.

Kind of hoped it would start a swamp cooler motor. Just a tad to much start surge I guess. Works on the furnace, I use a tankless water heater it to needs 120v. I haven’t tested it to much yet so I will update.

I just installed this smart switch for over 2 weeks but it is working perfectly. I use this switch to control a swamp cooler with 1/2 HP motor. I can turn on/off this switch over internet with my iPhone 6 anytime and anywhere. If it lasts long I will buy more (2 years warranty).

This came as a complementary with a B&H purchase. It's really bright and handy for wiring and electrical work in dark spaces.

We have had 2 electrical storms that have fried our switches connected to underground network wiring. I have installed these at both ends of outdoor run and have not had any surges since. Seem like they work as advertised.

Works as expected. FYI, it does not fit a standard electrical box.

I needed this box, not for wiring or conduit but to extend the camera down from my eave so a flood light is not in the way. It works perfectly and looks like it is part of the camera.

This little box saved us a lot of moving and re-wiring in setting up the automation system for our new shortwave stations. Definitely worth the price for the amount of labor it saved!

The HS210 wi-fi switch came with everything needed to make the wiring connections. The electrical box I have is deeper than the standard box, so accommodating� the somewhat large switch and the wiring was not a problem. Wiring is straight forward if you are familiar with wiring a 3-way circuit. Be aware that a neutral wire is required and not all switch boxes will have a neutral. In my case, I only needed one of the two switches in the box to make the circuit work correctly.� This may not be true in all cases. I'm going to use the second switch on another circuit.� The switch works flawlessly so far. Setting up the switch with the Kasa app was fairly simple. I just followed the directions in the app.� The only problem was I only needed one switch instead of the recommended two. The first switch was no problem, but the app would not let me continue, or quit without setting up the second switch, which I was not going to do.� I had to restart my phone to exit the app. The first switch worked as it should without having to set up the unused switch. The restart button located just under the switch is very touchy.� The switch restarted several times while I attached the cover plate. I used a double switch plate instead of the cover that came in the box and I had to make a few adjustments to get the cover to fit well over both switches. All in all, a very nice switch.

The box includes a small flathead screwdriver, wiring labeles and an adapter mounting plate. The instructions in the box were easy to follow and the thermostat will tell you if you are doing something wrong including a wire not in place. So once I had it wired and the wifi connected The install was complete. It’s been working flawlessly for the past 2 weeks.