Tivo Cr2032 Battery

I run through a bunch of CR2032 batteries every couple of months. I like these because battery life has been good, and I can buy them at a reasonable price through B&H.

The RAYOVAC CR2032 Lithium Battery (2-Pack) contained two, count-em two CR2032 cells. Absolutely amazing!!. These were purchased as spares, so I have not measured their voltage yet. Presumably, they will produce the rated 3 Volts and will last for 190 to 240 mAh. They are 20 mm in diameter, shiny and light weight and most likely contains some lithium & manganese dioxide so are technically a LiMn02 cells. FYI: They can explode if heated to more than 80 deg. C.

Works great, perfect for a small set of components (I have a Denon Receiver, Tivo, Sub Amp, PS4, and some smaller boxes, with plenty of space to spare for at least one more 2U sized bit of equipment). And the wheels are great for access, no more pulling everything off shelves and fiddling that way.

We decided to put real TV sound on our porch flat panel. Sonos is the only system that allows for a Dolby 5.1 system to be deployed without running wires. We used a PLAYBAR positioned beneath the TV and a Sonos BOOST to create a separate subnet for the SUB and two PLAY:3 speakers. The BOOST allows us to avoid any signal traffic interference with our porch wifi network. The BOOST also allows all of the wifi attached Sonos gear to look like a single device to the home network. The Sonos home theater gear all went together easily and configured quickly. We couldn't have been happier. We used an Ethernet drop to the porch to get the FiOS signal to both a Roku and a TiVo mini to drive the TV. We configured the TiVo remote control to handle the sound volume on the PLAYBAR and to select between the streaming sources ? Roku or TiVo/FiOS. Sonos made this configuration simple. The PLAYBAR/BOOST combination takes care of making sure the 5.1 volume is set correctly on the PLAYBAR/SUB/PLAY:3s. We were concerned that big sound would be difficult to pull off on a 20'x50' porch given that it was open on 3 sides. The sound field of the Sonos home theater system was mind boggling on every corner of the porch. We could turn it up to drowned out lawnmowers and leaf blowers. We actually mounted the TV/PLAYBAR/BOOST on a rolling cart (from Premier Mounts) so that it can be positioned to best suit where the audience is on the porch, or pushed back out of the way. We could not be happier with the way it turned out.

I purchased these to setup a MoCA network in my house for my Tivo Roamio 1Tb OTA and two Tivo Minis. I love the fact that I can use only one RG6 coax cable (ANT) coming out of the wall and one RG6 coax cable out of the Actiontech Adapter to the Tivo Roamio. With my setup, I only needed one since the Tivo Minis already have a MoCA Adapter built in.

Great small switcher. Used it to add a Blu-ray player, Xfinity cable box and Tivo DVR to one of the HDMI inputs on my Samsung HD TV. At first, the Tivo didn't want to connect but I simply turned off the TV and back on. Then everything started working perfectly. Now I switch between all three devices without any issues. Definitely recommended.

I needed a USB adapter to use on my series 2 TiVo system. I knew the TiVos had a difficult time with adapters (mostly since they can't take any kind of CDs), so I was a little nervous getting any adapter. But this product worked great! I just plugged it in and it worked! My older TiVo handled the device just fine with no problems. If you're looking for an adapter for a TiVo system, this product works perfect!!

I am using this with a Tivo Bolt. It is mounted outside of the Tivo case since the case only has room for a 2.5 drive, which failed. This drive has low power requirements, runs quietly and only gets slightly warm to the touch, even without a fan.

When I decided to wall-mount a 55 inch TV, I wanted as clean an installation as possible: no tethered boxes on a table below. That meant attaching a Fire Stick 4K, a Harmony Hub and an old TiVO Mini to the rear of the TV. The TiVO and Fire Stick were easy, but the Harmony Hub is made to sit on a horizontal surface, period. As I envisioned fabricating something out of metal strapping, I spotted the Mount-IT! MI-355 online. Perfect! And it was. I cross-strapped the Harmony Hub to it using nylon cable ties and secured it to the TV mount, neat and solid. Price is right, too.

Came as ordered with all connections. Simple installation and it works great streaming between my TiVo Premieres. It will not show MoCa on a Premiere, just ethernet connection. Worth the buy.