Top Podcasting Microphones

I use this stand for a table top mic stand when i am podcasting. It is adjustable and fits just about anywhere. if you are looking for a great stand for podcasting this works well. I now own two because they are so great

I use this for podcasting and it delivers!

I use this case to hold two to three lavalier microphones. It's well-built and the clear top allows you to see what's inside without opening it. Perfect!

Great headphones for podcasting.

I'm using this headphones for podcasting and I love it!

I use it for podcasting. It has been sturdy and dependable so far!

Works well for voiceovers and podcasting.

I am a professional videographer. This microphone is proving to be an excellent solution for video recording choral concerts. I always setup my camcorder at the back of the auditorium and need to set microphones much closer to the singers and in front of the audience as much as possible. I have routinely used wireless XLR clip-on transmitters on 2 microphones at the top of a tall microphone stand with a cross bar to hold the mics at 90-degrees to each other. That's an awkward amount of weight at the top of a skinny mic stand, and balancing the audio from both mics is always challenging. The AT8022 provides a much cleaner solution, with a single cable discreetly leading down the pole to near the base, where I connect the two transmitter modules to the right and left cable ends. In addition to being a cleaner setup, it gives me better access to the transmitter modules if I need to change batteries, turn them on/off, etc. The stereo separation is better than ever, and the microphone sensitivity seems to be nearly perfect for this application.

these windscreens are a quality product. i use them on my Shure SM57 microphones. they are simply placed over the top of the microphone & have a snug fit.these windscreens differ from the Shure brand windscreens in two significant ways. first, the Shure brand is far more expensive. second, the Shure brand requires a small, eyeglass-type screwdriver to lock the windscreen onto the microphone (the shure brand windscreens can be seen on any presidential podium since 1965).WindTech has provided a much easier, cost-effective, & acoustically transparent way of eliminating unwanted wind &/or pop noise from your microphone.

Once I figured out the colored rings around the top and bottom of the microphones it was very easy to set up. One mic comes pre set as mic A and one as mic B. I figured that, used the IR to set it and I was off and running. I can set this up with my Fender Passport Event or my smaller Anchor Audio AC 130+. This was $ less than the Shure microphone set up and I very happy that I purchased this over the Shure.