Types Of Pressure Washer Nozzles

Would only use Epson Ink as it does not clog the nozzles

Someone please tell me any other film washer better than this.

has huge power and nozzles to clean everything from computers to nick nack shelves.

A very pressure product exactly as I want

I make sure to print something once a month to keep the nozzles from drying out too much. I'm not sure how long they can go, but a month is working for me. Very happy with the print quality.

I tried a 3rd party ink in my R 1800 one time and it plugged the nozzles. After several cleaning cycles ink was sprayed through out the printer. So much for a warranty repair. Then I bought the R 2400.

This is great solution for people who take care of their electronics, especially PC, u can very quickly and securely clean your PC. It has several nozzles so u can reach every spot u need, even if it's very narrow. The cable quality is very good, the Duster itself is simple to use and save. The power is enough to fight with hurricane, and for such little thing it is unbelievable. I hope this review will be helpful :) P.S. I was searching for such thing for a long time and finally I've found it, highly recommend to all who needs it!

This printer replaced my aged Epson Stylus 4000. It was getting clogged nozzles too often. Compared to the 4000 which weight around 75 lbs, a bit noisy and was a large monster of a printer, this P900 is a nice change. It is much smaller, lighter and quieter. It doesn't have a built-in paper cutter for the optional paper roll stock. The amount of ink is also much less per cartridge compared to the 4000 but with 50ml per color that is just fine with me. The photos that this printer makes are excellent. I am very pleased with this P900.

This is a versatile cartridge for low volume quality printing at low cost. With only minimal care, the nozzles remain open.

My iP5100 kept giving an error message to check nozzles and press OK to terminate printing. Problem was, it gave the same error messages when I tried to print a nozzle test pattern. Since I couldn't print I couldn't check nozzles. I placed the printer in service mode, and was able to print a nozzle test pattern. Sure enough, half of the GY had no output. Replaced the printing head and all was well again. It takes a while because you have to drain ink, replace the head, refill ink, and print 8 pages to do a head alignment. It is worth it, because afterward, the printer does a beautiful job again.