Universal Ceiling Fan Remote Control Kit Manual

[This review was collected as part of a promotion.] My review for One For All universal Remote Control essential. 100% compatible guaranteed to work with all brands. It only took me a couple seconds to connect the remote to my tv. It is super easy you can connect up to 8 devices.

This electronic remote control is a must have for everyone. 100% better than a manual shutter release. Just point it at the camera and press. It's so small and light the only possible down side is it could get lost in your bag but the included case helps prevent that. A must have for every tripod shot.

I bought this remote control for my Canon M50 Mark II. To my surprise, Canon doesn't have a manual for the Canon M50 Mark II, even though they changed some options in the menu. All the videos you can find on YouTube are for the original model of M50. It took me a while to figure it out to make it work with my camera. It seems like the generic option is as good as this more expensive (branded) remote control.

This kit is well built, and is far more useful than I expected. The FIZ controller and two hand grips provide for countless control options, without limiting the imagination of the operator. The zoom rockers are small, but do allow for proportional speed control. I initially thought one motor was DOA, as it failed to move. It was due to my enthusiasm to test the system without reading the manual. Hint: calibrate the motors first, and then turn on the controllers. Honestly, I cannot think of any criticism of this gear. I can now use a great manual  lens with all the automation that I am used to.

I love all my Profoto products. They are phenomenal. I had a little difficulty at first with my D2 kit in the studio when using them with some of my older Norman and Photogenic lights in TTL mode, forgetting that once TTL with my Nikon Air remote, that i need to turn to manual when adding the other lights. Some of my other non-Profoto lights would misfire and the TTL exposures were all heavily underexposed. the other lights were not playing well with them in TTL modes. Once I thought about it, i remembered that I had to turn off the TTL setting on my remote after I had the balance that i wanted with just my Profotos firing before i added the non-TTL lights. The settings from my TTL exposures were held at the same levels once they were switched to manual. And these lights are powerful! I've been using my B1 kit and B2 kits on location for almost two years and have been waiting for the right time to get a studio kit as well. the D2 kit was worth the wait.

I tried several universal ceiling mount for my new JVC DAL-RS45 projector but not suitable for RS45. Peerless PRG-UNV ceiling mount is great suitable for JVC DLA-RS45 and precision gear design for roll and pitch adjestment. It's the most important for me to have precision adjustment. I am really satisfied of this PRG-UNV ceiling mount! MingChuan, Lu

I used this with a Peerless ceiling plate and universal flat screen mount to install 32 inch flat screen TV in garage. I have a similar set up in my lanai but it has a fixed length extension column. The adjustable was very easy to use and looks great. I did have to take both screws out of it to adjust it to the desired length. The screws go back in new holes that are exposed when you expand the column. This was a bit difficult because the threads had powdercoat over spray in them so have to be careful to avoid cross threading. Otherwise the usual Peerless high quality.

This universal projector ceiling mount is versatile and would adapt to any projector within its weight capacity limits. It comes with various sizes of mounting screw to fit any size. Highly recommended.

I replaced my hot-light setup with this kit and I am very happy. The equipment is sturdy and well constructed and the carry case is lightweight yet sturdy with a small footprint. The lighting temperature and intensity can be easy adjusted to match any situation that you encounter. The option to switch between the barn doors and the softer diffusers makes the kit perfect for video and photography shoots.  Upon arrival my kit was found to be missing the remote control unit. I contacted GVM directly and they took care of this immediately by overnighting a remote control unit to me. This is a great lighting setup for the price range with customer support that backs up their product.

Works like a champ! Extends the usefulness of the R1C1 kit and gives full remote control of the SB600, SB800 and SB900. Simple operation. Wish I had bought it years ago.