Use Wifi Router As Wireless Adapter

Use this on optimum and it is extremely fast over wireless and the perfect all in one Modem/Router combo.

I needed to connect an outdoor wireless security camera to Wifi but the signal on the main router wasn't strong enough to penetrate a thick masonry wall. The TP-link solved this problem. I set it up inside at the wall needing signal penetration but in line with the router. It worked perfectly - having a booster closer to the camera did the trick.

I got this to replace all of our wireless needs. I disabled wireless on our router and use this AP as our only source of wifi. The software is so amazing. We get better range and speeds in our home. Going to get the Ubiquiti USG and switch later.

I purchased this to increase the WiFi coverage in my house. I was considering purchasing 2, but started with 1 just to see the coverage. Overall, I get about 25% better signal at each end of the house with this set up in the center so an improvement over the WiFi router my ISP provides. I have basic networking experience and the software was a breeze to setup. I really think anyone could do it, but give yourself a good 15 mins to click around and understand their web interface. I simply plugged an ethernet cable into my existing WiFi router, then into the PoE adapter that came with the AP. Then just ran a second ethernet cable from the PoE adapter to the AP. Mounted it on a wall with their hardware and was done, took less than 5 min total.

I had an Asus PCIE adapter (wifi 5) previously. My wifi router was moved to the basement because of a router upgrade and cable wiring issues. I needed a secure router with wifi 6 and WPA3 that could get a decent connection on the 2rd floor up from the basement. This adapter has given me an 80% signal at 865 to 900Mbps download and slightly less for uploads. Installation was easy and I am very pleased so far with it.

This is just a modem with no wifi router. It works very well.

You can't go wrong with this router. Wifi 7 is fast.

Use this adapter on a U6-LR and AC-HD that are WiFi connected. Works as expected even though you may see a warning in the UNA GUI about the port does not supply sufficient power.

We have a n router, not an AC standard router, but, compared to the adapter built into our relatively new laptop, the wireless download speed increased from about 20 Mbps to 36. Our hard wired service from Comcast into the router is about 85-90 Mbps so there is speed loss in wireless, but it's much less with this adapter than the one that is built into our Dell laptop. Plus, if we ever buy a new router, (and possible upgrade our Comcast internet service), we may be able to take advantage of the higher AC band speed.

Using this with NEC NP-M352WS 3500-Lumen Portable Short Throw DLP Projector. Powerpoint slides are about 1 second delayed. No audio via the wireless adapter. However, I am happy with the device for my purposes. I also use a hard wire for audio/video usage. After the second round of ordering, receiving, and returning the first order of the projector and this adapter, an with level II NEC tech support, I am finally able to get the devices to work together. Also, I am not going to be using this on a wireless network/router, but through the Easy Connection option (no router present at installation). It came down to one simple operation (from Mac OS 6.8): Before starting the process below, you will need to get the wireless IP address of the projector. Mine was 10.0.39.155. -click on the wireless icon at the top of the screen -click on Open Network Preferences -click on Advanced -click on TCP/IP tab -change the Configure IPv4 setting to Manually -change the IPv4 Address: to something close to your video projector's (my instance: 10.0.39.160) -click OK and then Apply Don't forget to reverse this setting when you're done using the wireless adapter in order to connect to the internet normally. Hope this helps.