Used Front Loader Washer

Received today, I wont get to deep in the unboxing as its very easy and the paperwork is child proof. It all fit together and even shows you where on the cartridge to put your finger pressure when replacing the ink for best results. A few things to think about. First I used ultra smooth fine art paper from Epson, it will feed through the top loader sometimes, though much more consistent in the front loader. BUT...It must be Very straight, use the lines on the entrance tabs and make sure the are lined up Perfectly on each side or you will repeat until its perfect, and this is done by hand, the feeder will not straighten it for you if you start it even a little bit off line. I was able to print out all the pictures you see on the rack (13 )with the starter inks, I ran out of light grey first then light vivid magenta. I got 4 prints after the light black low prompt came on the little screen on the printer, the computer will tell you well before that. A bit to much play in some of the plastic covers, and the feed tray cover on the front feed Must be closed each time after you feed it before you print. It will load but will not print until closed but there is a prompt to do so. Maintenance box is about 15 percent full after all these prints and setup, so with an extra box included you have plenty of time, most came form initial setup of inks. I actually think its faster than the average review says, but I have never been a production printer and I usually do not print border-less, I mat my most of work and its just covering up Very expensive inks. The little screen is very well thought out, bright, clear and menu items easy to find, its a touch screen that swivels up but Its tight enough and does not move when you use it. I will edit this if I find anything that may be of use. I am glad to have it,.... and as ALWAYS.... very pleased with the way B&H provides the best shopping experience available online or in store....

I like the size of this insert. It fits nicely into all my front loader backpacks, so I'm not limited to a "photo backpack ". Also it is just right for my z7, 15-30, 24-70 and 70-200 all f/4. Plus batteries and a few filters.

I purchased the Back Loader but I did not like zipping it up and flipping it over to access the front panel. The Font Loader works. For Travel with 2 camera bodies, lenses, drone, mics and accessories the Pro Light Front Loader is great.

Someone please tell me any other film washer better than this.

Just what I needed to use my top loader with my action x.

Used to protect the front element of my L series Canon lens

Used for front presence speakers in 7.1 surround system. High quality.

Used for lens protection on a Zeiss ZM 50mm 1.5 C T*. I have a Tiffen Haze-1 on most of my wide-angle to slight telephoto lenses (over 105mm 35mm film equivalent, I go with a Haze-2...) I say most as there are a few exception, like a Ektar 150mm (that takes a series V, no longer made...) and a Micro-Nikkor 55mm(that doesn't need the protection, the front element is more than 1 from the front of the lens) and a couple of lenses that have Hoya filters on them.

Used to protect your lens from damage to the front glass. I use it on Nikon Z mount lens so that I know it was made to the same standars as my lens.

Used mostly as protection for the front of my lens.... Does a great job - great fit+finish.....