Vintage Stereo Receiver Power

I hooked these up to a vintage stereo receiver and they sound great. These sound better than the original speakers that I had back in 1980.... Love these

I was looking for a receiver compatible with my "vintage" 1980's stereo system. This item was perfect for connecting my turntable, tape deck and cd player and it gets the best from the output of each. I do miss the function buttons on the front panel and the FM antenna is rather limited but it was an outstanding bargain meeting my needs. I do not regret this purchase in any respect.

using this power block to protect and run vintage Marantz 2010 stereo power amp, Sony tape deck, Sony CD player and Pioneer PL-512 turntable. upgraded to this power block for extra safety on my electronics. will buy again to pair with a 4-10 Classic 50 guitar amp and accessories and a 100w Fender Bassman head and speaker rig. rugged quality, nice long cord, easy read lights. plug and play.

The MM7025 replaced a vintage power amplifier and gave new life to my dedicated stereo system. I have both analogue and digital sources, a PrimaLuna tubed preamplifier and B&W 702 S2 floor standing speakers, and this Marantz has proved to be a fundamental link in this chain. It leans a little to the warm side (which I like) and improved the sound of my speakers, with tight bass, very sweet highs, and transparent voices. At this prices level, I can't imagine anything better. 100% recommended.

Purchased this receiver to power a pair of Klipsch Quartet vintage speakers. This receiver has more than enough power to easily drive my Klipsch speakers to concert levels. No need for bells and whistles or a subwoofer in my setup. The receiver delivers all that is needed to listen to great stereo recordings from traditional media sources,

The 5V iFi Power is powering my bluetooth receiver for my vintage amp. Music streamed from my iphone now has an expanded sound stage and a lower noise floor. Sounds great.

The best stereo receiver I’ve ever owned! If you want the best, this is it!

This stereo receiver was one of my better online purchases!

I just bought a power amp for my stereo that I've waited over a year to save up for. I have a ten year old receiver and wanted a good cable to connect them. I never knew there was a shielded cable that was exactly the right length with a RCA male on one end for the receiver and a 3-pin XLR male on the other for the amp. For under $ I was able to connect my 3 channel power amp to the receiver with no interference from all of the other A/V equipment I use. I was an electronics technician in the Navy and know that this was the best option for my system possible. I couldn't be happier with my purchase.

After my stereo receiver died, I needed a way to play my old vinyl music. I got this preamp to connect my turntable to my PA System! So now it's nice and loud, and full sounding. Note: You still will need to ground your turntable to your audio power chassis, or you'll hear hum. Remedy: Wire audio ground wire (not power ground) up to a screw on the back of your audio system.