Voltage In A Aa Battery

Phantom power only-- no AA battery.

I need to order more of AA battery holders. I love what I have

I like the two std Canon battery mode. Have not had success with the 6 AA mode yet.

Cool AA Battery Holder... (spare battery for my Canon Speedlite) Sturdy and well designed.

Battery powered by a single AA battery. Excellent sound quality. Easy to use.

So I'll just get this out of the way... the battery life IS as bad as everyone says. HOWEVER, if you switch the meter to voltage, you'll see how much power you actually have left. Aftermarket batteries don't give accurate readings. So, first upgrade, after a cage and T5 should definitely be a V mount. Aside from that WOAH BABY! The performance is exactly what I was hoping for! Shot on a GH5 before. And now I look at that camera like it's going to collect dust or just be the in case backup. No stabilization, no problem though if you have a solid gimbal setup. The image is INSANE!

Battery charger for up to 8 AA or AAA NiMH NiCd batteries. It also will tell you if a battery is no good. You can also completely drain a battery on it before a recharge, which extends the life and strength of the battery. The only setback is that this is not a fast charger, so extra batteries are needed if one is doing a lot of flash work with remotes.

Awesome battery holder for 12 AA batteries (mainly use as back up to my Canon Speedlite 4 AA and Battery Pack 8 AA). Well designed. Much better than those battery storage cases 4 AA or 4 AAA + 1 AA I've purchased.

If you're using the BMPCC 6K Camera while also powering the Samsung T5 SSD and perhaps using phantom power then you need this battery. I have two. They each last around 3 hours. New Official Canon LP-E6N Batteries last only 17-22 minutes under that load. The microphone I am using is the Sennheiser MKE-600 Shotgun Mic so you might wonder why I don't simply use an AA battery and skip the Phantom Power. The reason is Phantom Power provides a hotter signal which produces better sounding audio vs the AA Battery. I tried using just one Core SWX Battery and mixing in (8) LP-E6N's, but switching out the short life LP-E6N's became too much of a hassle so I opted for the 2nd Core SWX.

In a rechargeable battery the important things are 1. Ability to hold charge 2. Provide the expected voltage at terminals when charged 3. Capacity to hold enough charge (mAhour capacity) 4. Ability to be charged repeatedly When I got the batteries they were not charged but this was stated so I charged the batteries. All 16 charged up and provided expected voltage (actually a little bit higher, about 1.44 Volts). I don’t have a battery tester so I am unable to say if they charged up to expected mAhour capacity. However, since they seem to be performing OK , I will assume they charged appropriately. I am unable to say anything about how many times they can be charged since that is a long term test. So far they have performed. Five stars. Ajeet S.