Wash Machine Rubber Seal

I like the size and the replaceable rubber seal on case

Having gone through three tanks already (AP, Patterson, and a stainless steel one), I'm happy to announce that this is the most satisfactory. Even though it's a screw-on (in comparison to the Patterson easy-snap funnel lid) for lid, its top is what I think is great. It doesn't leak thank to it's rubber seal, even though some water remains unless you remove the rubber seal which is easy to do. All and all, it's a wonderful tank, and I intend to keep it for a very long time.

Pelican make some of the best cases. These have easy to open latches that still seal well when closed. The cases are well built and have a rubber seal for water resistance.

sincerely this lens was better than I expected, built in a alloy barrel with a rubber seal ring, weather sealed, Very Sharp and chromatic Aberration is None or close to none, the distortion is near to zero witch is rare in a gran angular lens witch mean the lens was made it with a good quality glass, pretty impressed with this lens, since I got it like a month ago, is mounted in my camera 75% percent of the time .... love it and looking forward to get more from lens IRIX . Totally recommend 👌

Experience with waterproof products that use rubber seals is to always have a spare seal. If the original fails, and you have no spare, you might as well carry your expensive gear in a card board box. B&H has the right accessories for the products I buy from them, and at a decent price.

This adapter is solid! And has rubber seal for some dust-poof/splash-proof capabilities. No lens wiggle un my Lumix S5!! Awesome adapter.

This windshield has worked great for me. Not only does it block wind, but the tight rubber seal blocks any other sounds coming from behind the mic. I even use it indoors sometimes to block out some ambient noises. Just make sure the mic is off when you take the windshield on and off, as it's so tight that the inside tends to scrape against the mic which can be very loud or possibly even damaging if the mic is on.

Great little light. Uses 2X AA batteries, and has excellent light output for its size. I've tested/owned a number of small "inspector" size lights from other manufacturers in the past, and I always seem to have a problem with them not staying on or flickering which required me to keep twisting at it trying to keep it on or on at full power when I needed it most. This light does not have that issue. There is a nicely recessed on/off switch in the butt, with a rubber seal to keep it dry. This unit is also quite light, much better than a comparable metal housing, and more scratch resistant too. I've never tested the PolySteel line, but I feel I'll be a fan moving forward based on the grip and lightness of it. It's light enough that I can keep it with me and not be worried about it pulling at my pocket all the time. The clip is loose enough to easily slip over my pants pocket, but tight enough to keep it from falling out all the time when I'm climbing around on the floor or ceilings. My only tiny issue is that the on/off button is a bit hard to press depending on how you're holding the light. I don't have a huge problem with it, but my GF had to user the tip of her finger nail to activate it, which will either break her nail and/or eventually puncture the rubber seal on the button. Overall, I really like the light, and look forward to more lengthy and rougher testing. Disclaimer, I received this light as a tester product for free, but my review is unaffected by this.

This cold shoe is safe to use on the new Canon 600 EX speed lights with the rubber seal. Simple and good product.

I ordered this to go along with my Einstein / GH4 and the�PocketWizard Flextt5 for Panasonic. It's well built and has a protective rubber seal to cover the protruding end when it's not in use. I just plugged it in and it was ready to go. Works great and super easy to use.