White Bookshelf With Pull Out Trays On Bottom

Well made trays, each with three wide depressions in the bottom to allow print tongs to get under the print. I use the gray for developer, the red for stop bath (color appropriate!)and the white for fixer. I also bought a second white tray for fixer remover. The pour spout works well for emptying, and there are three notches on the left side to hold a thermometer. Good design in a reasonably priced tray.

I have small bookshelf speakers in my basement gym. I also have an older amp with NO subwoofer jack. No problem! This handles all the shortcomings. The directions are simple. I just ran cable from the speaker OUT to the woofer IN. Then from the woofer OUT to the speakers. Don't forget to turn up the base control on the back of the woofer. Sounds Great!!!

I have several different makes of trays but these are my favorite. The right amount of sturdiness and the ribbed bottom make it very easy to get a hold of whatever you are processing.

For inexpensive trays they work very well. Less chemical required due to a non guttered bottom. The front rocks nicely without lifting the tray giving a nice smooth slosh of chemical. Lightweight and easily cleaned.

These trays are great to use. Your prints will not stick to the bottom. The trays are big enough to enable easy use of tongs and small enough to allow economical quantities of chemicals. They are also easy to clean and store and a compensating temperature probe fits close to the bottom. I wish I had discovered them years ago!

These low cost, durable trays are the best. I have 5 of them. They have groves in the bottom that make it easy for tongs to pick up prints and the corner drain is at the correct angle to prevent spillage when pouring chemicals into a bottle. I highly recommend them. They will last for years.

Purchased for my annual Super Bowl party. Out on a big pull down screen in my patio and placed projector there’s. During daylight hours picture is a little washed out as e no g set in it was beautiful and clear. Sound and pic great. Easy to use hook up and stream. Also hooked up to IPhone. Love it.

5 stars! Stable and very easy to adjust level with slider on.

FITS LIKE IT SHOULD TIGHT IN THE BOTTOM AND WILL NOT COME OUT ON ITS OWN

Excellent case. PSU shroud being on top gives the three 140mm on the bottom the most space to pull in air from the bottom. Love how the side and top panels just pop right on and off and you have the option to screw them shut if needed. Lots of airflow in the case and pushes everything up and towards the back of the case where the big perforations are. The 180mm fans are a bit loud but you can tune them with a fan curve. The back has plenty of grommets to route all the cables you need and room for cable management.