Windows Run Computer Management

I'm an IT student and I needed more memory for my computer to be able to run virtual machines and do multiple windows. I needed more than my 8G that my computer had. I opened the computer and 10 minutes later I was done.

This really sped up my computer hugely. I sometimes run virtual machines on my computer, and with this my virtual machines run so quickly. It's a big difference from when I had different storage in my computer. One other nice thing is you can update the firmware without Windows. I use Linux, and it really helps to have firmware you can update without needing Windows;

...After downloading the drivers needed to run it with Windows 7.....

DC Technical Support is useless. The issues with using this are embedded in Windows 10 control panel and the new Color Management. Not only do you have to change the config in the printer driver and your Image software i.e., Photoshop, you also have to go into the Windows 10 Color Management and disable Windows color management for the given device before you even start. Without doing this, the spectrophotometer gives periodic errors. You have to then import your generated profiles into this cache, which doesn't recognize the profiles in the directory until you import them. To get it to work properly, you have to assign in Photoshop, but you also have to tell the OS about the profile or it will still fail.

Easy to install onto Windows 10 - immediately recognized. Loaded Logitech's software and their management utilities are easy to use. Image is crystal clear with good color, brightness, etc.

If you don't have any Ubiquiti devices on your network you'll need something to manage them. Installation of their Windows management software was easy. Setup took just a few minutes and performance is better than our previous EnGenius and TP-Link access points. It's been trouble-free and well appreciated by all users. I'm sold on Ubiquiti.

Sets up with disk management in Windows 10 in just a few seconds and seems a very fast drive. Was a great deal on sale.

I spent a long time looking into various 5.1 surround bass management solutions that would work with regular Windows audio as well as audio through a DAW for studio and game development use. There are various software solutions for each, but most would not give consistent results between Windows system and DAW audio. I started looking for either a bass management hardware unit (some add latency) or a surround controller with bass management (way more expensive than this sub), then came upon the few Genelec subwoofers which have built-in surround bass management. I only have a 5.1 surround system so I chose this sub, and am happy I did so. While the cost is higher than I would like, there aren't that many other subs that handle surround bass management, and it handles both bass management and LFE duties well. The manual is comprehensive, and there are little switches and a knob on the side that allow you to customize rolloff, boosts, power saving, 4 phases, and sensitivity. Noise floor is very low, and it pumps out enough oomph for my calibrated small home studio even with the largest rolloff as well as the lowest input sensitivity. I'm not using it to shake the house, but rather to hear the lowest frequencies correctly while mixing and listening to all kinds of stuff. It's also smaller than some other subs, and that's a plus for my room as well. I don't really have anything to complain about for this sub other than Genelec's pricing, but since there are few subs that handle surround bass management and I didn't find any cheaper than this, it is what it is. Great product.

I could not upgrade the firmware from Godox through my windows 10. So after a computer professional looked over the situation said that Windows 10 would not recognize the upgrade due to the time Godox wrote the firmware upgrade. He used Windows 7 and the firmware upgrade worked.

Plugged in, run fast on my computer. What more could you ask for?