Wired Long Cable Stereo Headphones

TR of the 3.5mm end of this cable are both wired to pin 2 of the XLR, so your stereo information gets summed to mono. Pins 1 & 3 of the XLR are connected to shield. XLR connector is by Rean and very nice.

Still like my wired headphones

I have two sets of wired headphones that I need to keep switching between. Now that I have this Y cable, I can keep them both connected and just grab the set that I need. It may not seem like a big deal, but constantly switching the set that is connected to the headphone jack when you are holding an instrument quickly gets to be a pain. Best of all, this is a very well made unit that was well worth the $10 price tag.

As long-term marshall user I've owned and used all their wired headphones this is my 1st attemt at wireless and I can state. They are just the right choice !

[This review was collected as part of a promotion.] This works well for long flights. I can use my older wired headphones and still keep my phone charged. I’m happy to have it. I would recommend buying this to keep in your travel accessory bag for long trips

I needed a headphone holder to keep my headphones and headphone extension cable handy and organized by my stereo sound system. This product is of sturdy aluminum constriction and should work well for its purpose. Installation was quick and easy as well.

You can get 2 headphones going at once with this cable. Well made, seems durable. Should last a long time.

amazing headphones! good quality! long cable! just amazing! recommended.

Best cable, wired sound, long enough, comfortable, light weight, easy to find. easy to unwrap.

The DM-E1 works perfectly with our EOS R5, EOS R and EOS RP Cameras. Sound is clear and the mic has a wide, flat frequency response. This is a true stereo array in a single housing that looks like a plain mono shotgun. The variable angle settings are a huge advantage for music recording situations and allow simple control of the amount of room reverb present. The internal electronics are quiet and the sensitivity is relatively high. When mounted directly on a hot-shoe it's possible to pick up some focus motor noise,, but moving the mic a few inches away with a Vello, or similar multi-cold-shoe bracket will minimize that noise pick-up. The attached cable is long enough for use with a 5 to 7 inch offset bracket. Off camera use is possible as long as you have a well-shielded 3.5 mm stereo mic extension cable. Be sure to use a shielded microphone extension, NOT one an unshielded one intended for headphone use. Also, it's probably a good idea to always carry a spare 2032 coin cell battery since this mic is useless if the battery dies.