Wireless Audio Adapter For Speakers

Use it with wireless speakers and amp. Able to mix wireless with wired and beautiful audio.

This is the perfect ideal adapter for using active speakers in a wireless capacity. Specifically, I use the Sennheiser wireless systems to send the signal to the speakers remotely. This adapter is for the needed for the Sennheiser transmitter/receiver packs for providing constant power verses using batteries. I hide the transmitter/receiver packs on top of each speaker out of site from the public and being able to plug them in to the same cord as the active speaker.

[This review was collected as part of a promotion.] I recently bought Belkin Airplay 2 audio adapter for my old Bose music speakers and for my RV audio system. It is compact and easy to install. The sound quality while streaming is awesome and there is no connection loss with my HIFI music speakers. I am loving it playing music on my non wireless speakers and it literally gave life to my old speakers. Airplay connection with this is seamless and on one click and no searching for device while connecting , just tap and you are connected. I would definitely recommend this product for those who don’t want to spend hasty money to get new wireless speakers. It’s makes your old audio devices works as new wireless speakers. No need for wired connection. With one tap you can have friends connect to your device and play their music.

Bought a pair of these for two ION Audio Stadium Wireless Rechargeable Speakers. The 6' length allowed me to connect easily to my oversized Halloween props. Recommended!

Using this with NEC NP-M352WS 3500-Lumen Portable Short Throw DLP Projector. Powerpoint slides are about 1 second delayed. No audio via the wireless adapter. However, I am happy with the device for my purposes. I also use a hard wire for audio/video usage. After the second round of ordering, receiving, and returning the first order of the projector and this adapter, an with level II NEC tech support, I am finally able to get the devices to work together. Also, I am not going to be using this on a wireless network/router, but through the Easy Connection option (no router present at installation). It came down to one simple operation (from Mac OS 6.8): Before starting the process below, you will need to get the wireless IP address of the projector. Mine was 10.0.39.155. -click on the wireless icon at the top of the screen -click on Open Network Preferences -click on Advanced -click on TCP/IP tab -change the Configure IPv4 setting to Manually -change the IPv4 Address: to something close to your video projector's (my instance: 10.0.39.160) -click OK and then Apply Don't forget to reverse this setting when you're done using the wireless adapter in order to connect to the internet normally. Hope this helps.

I was led to believe that I might need to add an adapter to live stream audio with a wireless mic from my sennheiser wireless setup, but it will connect right to my iPhone XS from the sennheiser receiver and the livestream audio is clean

This adapter makes the wireless go mic way better.

I am impressed by the Awesome Audio from these speakers. I replaced speakers that were almost fourteen years that required a volume adjust between voice and other audio. If the voice was too low I had to raise the volume and then lower the volume for other audio and vice versa. With the Sony Speakers one setting for volume between voice and other audio is all that is required for watching movies. There are audio in previous viewed movies that I have never heard before. Great choice for Speakers!

If you have rokutv a must have wireless speakers by roku

best use adapter for wireless remote controller