Wiring Pro Controller To Switch

The switch was quickly adopted by the controller and was up and running in a few minutes.

The HS210 wi-fi switch came with everything needed to make the wiring connections. The electrical box I have is deeper than the standard box, so accommodating� the somewhat large switch and the wiring was not a problem. Wiring is straight forward if you are familiar with wiring a 3-way circuit. Be aware that a neutral wire is required and not all switch boxes will have a neutral. In my case, I only needed one of the two switches in the box to make the circuit work correctly.� This may not be true in all cases. I'm going to use the second switch on another circuit.� The switch works flawlessly so far. Setting up the switch with the Kasa app was fairly simple. I just followed the directions in the app.� The only problem was I only needed one switch instead of the recommended two. The first switch was no problem, but the app would not let me continue, or quit without setting up the second switch, which I was not going to do.� I had to restart my phone to exit the app. The first switch worked as it should without having to set up the unused switch. The restart button located just under the switch is very touchy.� The switch restarted several times while I attached the cover plate. I used a double switch plate instead of the cover that came in the box and I had to make a few adjustments to get the cover to fit well over both switches. All in all, a very nice switch.

Using this switch to extend network connections in an old building with limited network wiring. I'm powering a Cisco 1600 series access point from this switch with no problems.

I am upgrading my IP camera wiring to include patch panels, keystone jacks, Cat6 cable, and I wanted a single PoE Switch that could handle it all. I don't have all old cameras pluse the newer ones ported over yet but the switch runs very cool at the power supply and the switch itself. I think that running cool may lead to a longer component life. The switch is plugged into a full sinewave UPS also bought from B&H. I chose this switch which was more expensive than the slightly less powerful model but cheaper unit. One benefit this switch has is apparently the ability to recover from a short. One camera connection had a leak induced short and the switch turned off the port. I don't reccomend testing this on your setup but the switch port is fine.

Makes using controller software simple as plugging into switch

My Ubiquiti controller adopted and updated the switch perfectly.

This is exactly what I needed for my unifi pro and switch !

Everything looks much better now that the wiring is organized.

Replaced my existing firewall, dhcp controller and network switch with ubiquity controller and network switch along with 3 ubiquity access points. It was a painless installation and network speeds are much faster.

This switch has been up and running for two weeks without problems. It was easy to install and configure with the unifi controller. You do not have to be an IT professional to deploy this thing in your home but having the unifi controller for your network devices really gives you an incentive to learn what you can truly do with these things, which is alot! A+++