X Box Controller Image Outline

I use these cases for scoped rifles, outline the rifles, use electric knife to cut out and bam, rifles fit in like a glove, only wish they made them 6 longer... Very well made, and easy to secure. Can't go wrong...

Worked perfect right out of the box, combined with the onix controller. Only have used them two times so far, but no complaints.

Specifications look correct but the image does not match what arrives in the box.

This wall controller outputs a great image and is made for regular consumer televisions. It has the capability to flip any screen that you desire to flip. I am very satisfied with this product.

Perfect works with DSLR controller app for Android so much better with out wires. Is slow with image review but almost same speed at times with usb cable.

This case is the best looking case I have seen for compact-flash cards. It has a quality gunmetal exterior. When placed in the foam outline, they fit securely. The case itself holds 4 cards in a dustproof container.

Fantastic for directing the light where you want it to be. It is also very effective as a hair light or a rim light to outline a model or a product

Perfect fit, camo helps break up outline, provides some protection from small bumps or dirt. Doesn't protect against heavy impacts, but this will definitely prolong the lens's lifespan.

I have been using this for my Olympus OM-D E-M1 Mk2 and Mk3. I tried to use glass type protector by Vello for E-M1 Mk2, but it didn't work since outline frame portion of back screen is higher than screen surface, and the glass type protector is little bigger size than screen area. Then, I purchased this film type thinking I can cut the outline and can make it smaller to install, if necessary. But this film type is smaller and perfectly fit to the screen size. It is thick enough to provides same good appearance, durability and touch screen function with glass type. Also, the film type is thin enough to make the rear screen to fold back inside direction which glass type couldn't due to its thickness.

I purchased this case to store my Buck Mark Standard .22 pistol w/Burris Red Dot sight. It only took about 30 minutes to outline the pistol and remove the outlined foam. I then cut the foam outline in half crosswise and reinserted one layer of the foam outline back into the case. This way the pistol would sit even with the top of the foam layer. When the case lid is closed the pistol is held quite firmly in place. I even had extra room for three magazine storage slots. I am very satisfied with this product and highly recommend it for the safe storage of your items.