Xps Battery Charger Lights Flashing

flashing lights indicate charge level roughly.

As many others mentioned in the reviews, these batteries are now new old stock, as the newest ones were made in 2022 and will arrive completely discharged. DO NOT give up on them - the charger will initially show an error (chamber and calibration light flashing) - keep taking the battery off and putting it back on, and eventually it will start to charge. The key is to not leave it in the charger if the charger is showing the error code, you have to remove and replace the battery until the charger shows that it is charging (chamber light and 50% light flashing). After a few hours the 50% light should glow solid and 80% should start flashing, and eventually it will charge fully

Does its job. I like how the flashing of the lights lets you know where you are in the charge cycle.

Works great. The flashing lights are an easy way to see how the charge is progressing.

Router is simple and faster than my previous D-link at 150mbps.I like that I don't have to see all the flashing lights.

This is so much better than the single charger that comes with the camera because it has two chargers AND mostly because you can tell how fully charged it is without just waiting for the charger to stop flashing. Huge improvement.

I keep the Poly-Steel 700 in my truck because of the fact it has the red flashing light on it. If I would have trouble I can just turn it on and stick it to the truck since it also has a magnet. It has the zoom on the front end and all the lights are bright. I have several Coast lights and all of them are high quality and well designed. I will always be a Coast customer. The warranty and customer service is second to none.

Works as advertised! Portable,flashing lights with a high squeal! Just pull out the pin if one has to do small piece of mind! Better to have it than not! Safety with it!

Nice heavy flashlight with some nice features, the magnet on the end, the side lights, the red flashing lights. I keep one in my car and one by my desk!

I own or have owned every light known to man. (ok, slight exaggeration). I currently have the Gemini Soft, Gemini Hard. and Kino Freestyle LEDs of a variety of sizes. Never mind Apurtures and Nanlites plus a few of them lightweight flexible led panels. But when I need a fast and simple setup, I always got back to these Astra Softs. And when I look at the image, I wonder why I went and bought all those other expensive fixtures. Just today I shot a multicamera interview for ABC's new show Impact with the U.S Attorney investigating the Matthew Perry case and because going thru security was so complicated and time was of essence, I chose to bring these lights instead. I loved the picture to much I wondered to myself why I keep buying these way more expensive fancy lights. And the beauty of these is that I can fly them with a micro 150 battery and because I rarely have to turn them up all the way, they will last the length of some of these long interviews no problem. I did notice on this thread some folks complaining about these lights failing them, and have heard similar complaints from other Astras too. I have never had any issues with these or my other Astras, but that's likely because I read the instructions that clearly state you should dim the lights all the way down before you turn them on, wait until the flashing green light stops flashing, and then dim up at your heart's desire. And always before I turn them off, I dim them down all the way, as not to forget. That might be the secret. I see people using them wrong all over the place.