Create a tailored car mount by connecting the 7" units of 5/8" Rigging Rod from CineMilled. This set of two rods is solid for strength and milled from 6061-T6 aluminum. It is an integral part of the Houdini ecosystem, compatible with the clamps that hold the car mount together. Endlessly customizable, this rigging method enables very specific positioning of your camera to capture each angle on the storyboard.

Solid 6061-T6 Aluminum    5/8" Diameter, 7" Length    Use for Rigging Equipment to Car    Compatible with CineMilled Houdini Items

• Use for rigging of any number of things inside or outside vehicles.
• 7" length for full customization of your car mount.
• 5/8" of solid 6061-T6 aluminum.

Related Questions and Answers

Q: 1. What is the female thread size on these? M12? 10mm?

A: The female tread size on the PolarPro Extension Rods is 10mm.

Q: 2. What would be the height of these when installed?

A: The exact height is not listed. However these are shoes which are very thin. They are going to be only a matter of a few millimeters tall. They are not going to make much of a difference in the height of the product.

Q: 3. Does run/stop button on the pistol grip actually trigger the video recording function of a5100? or is it only works for still shooting?

A: Hi Jihoon - yes, the grip triggers video start/stop. thanks for asking!

Q: 4. Does the retroFlex-S cage fit the a6500?

A: Hi Claudiothanks for asking. It will work without being centered, but if you are set on that, you'll need to pick up some third party gear to make that work. An arca-swiss style plate with a screw slot should work just fine for that. I hope that helps

Q: 5. Does it fit with sony alpha a7 iii?

A: Hi Carlos - the retroFlex is designed for the Sony Alpha 5000 and 6000 series cameras

Q: 6. So I want to fly my Sony fs700 on a Dji Ronin. Would this allow me enough wiggle room to operate efficiently or would I need additional parts?

A: You will be good with these two parts. If you were to add equipment to the back of the camera, say a battery, you would also need the CineMilled Pan Arm Extension for DJI Ronin Gen. 2 (Short) B&H # CICM502 or possibly the Long version. CineMilled Pan Arm Extension for DJI Ronin Gen. 2 (Long) B&H # CICM503 But if you are using just the FS700 and nothing on the back, the two extensions will be just fine.

Q: 7. Can this be used as a counter weight for monopods and is it male and female 1/4" threads on it?

A: Yes, it may be used as a counterweight and yes, it does have male and female 1/4 20 threads.

Q: 8. Will the Ronin still fit in the standard case once these are installed?

A: yes it will

Q: 9. Will these fit a Ronin 2?

A: The Ronin 2 and the Movi Pro Ring both use a bar that is 30mm in width. This should work on the Ronin 2 as well as the Movi Pro Ring.

Q: 10. Special order

A: At the time of this posting, February 5th 2018, this part is in stock. It is not a Special Order Product.